All of lore.kernel.org
 help / color / mirror / Atom feed
From: Jarkko Sakkinen <jarkko.sakkinen@linux.intel.com>
To: amirmizi6@gmail.com
Cc: Eyal.Cohen@nuvoton.com, oshrialkoby85@gmail.com,
	alexander.steffen@infineon.com, robh+dt@kernel.org,
	peterhuewe@gmx.de, christophe-h.richard@st.com, jgg@ziepe.ca,
	arnd@arndb.de, gregkh@linuxfoundation.org,
	devicetree@vger.kernel.org, linux-kernel@vger.kernel.org,
	linux-integrity@vger.kernel.org, oshri.alkoby@nuvoton.com,
	tmaimon77@gmail.com, gcwilson@us.ibm.com, kgoldman@us.ibm.com,
	Dan.Morav@nuvoton.com, oren.tanami@nuvoton.com,
	shmulik.hager@nuvoton.com, amir.mizinski@nuvoton.com,
	Christophe Ricard <christophe-h.ricard@st.com>
Subject: Re: [PATCH v12 4/9] tpm: tpm_tis: Add verify_data_integrity handle to tpm_tis_phy_ops
Date: Fri, 26 Jun 2020 01:02:11 +0300	[thread overview]
Message-ID: <20200625220211.GJ20341@linux.intel.com> (raw)
In-Reply-To: <20200625144650.269719-5-amirmizi6@gmail.com>

On Thu, Jun 25, 2020 at 05:46:44PM +0300, amirmizi6@gmail.com wrote:
> From: Amir Mizinski <amirmizi6@gmail.com>
> 
> When using I2C bus protocol, the TPM has the ability to report data
> integrity on incoming or outgoing command parameter bytes.
> According to the TCG specs, if this data validation functionality is
> enabled via the TPM_DATA_CSUM_ENABLE register, the TPM will update the
> TPM_DATA_CSUM register after reception of the last command byte and after
> the last response byte has been read.
> 
> Data integrity is checked if a "verify_data_integrity" handle is defined in
> "tpm_tis_phy_ops".
> 
> Co-developed-by: Christophe Ricard <christophe-h.ricard@st.com>
> Signed-off-by: Christophe Ricard <christophe-h.ricard@st.com>
> Signed-off-by: Amir Mizinski <amirmizi6@gmail.com>
> ---
>  drivers/char/tpm/tpm_tis_core.c | 14 ++++++++++++++
>  drivers/char/tpm/tpm_tis_core.h |  2 ++
>  2 files changed, 16 insertions(+)
> 
> diff --git a/drivers/char/tpm/tpm_tis_core.c b/drivers/char/tpm/tpm_tis_core.c
> index e136467..347c020 100644
> --- a/drivers/char/tpm/tpm_tis_core.c
> +++ b/drivers/char/tpm/tpm_tis_core.c
> @@ -347,6 +347,13 @@ static int __tpm_tis_recv(struct tpm_chip *chip, u8 *buf, size_t count)
>  		return size;
>  	}
>  
> +	if (priv->phy_ops->verify_data_integrity)
> +		if (!priv->phy_ops->verify_data_integrity(priv, buf,
> +							  size)) {
> +			size = -EIO;
> +			return size;
> +		}
> +
>  	return size;
>  }
>  
> @@ -419,6 +426,13 @@ static int tpm_tis_send_data(struct tpm_chip *chip, const u8 *buf, size_t len)
>  		return rc;
>  	}
>  
> +	if (priv->phy_ops->verify_data_integrity) {
> +		if (!priv->phy_ops->verify_data_integrity(priv, buf, len)) {
> +			rc = -EIO;
> +			return rc;
> +		}
> +	}
> +
>  	return 0;
>  }
>  
> diff --git a/drivers/char/tpm/tpm_tis_core.h b/drivers/char/tpm/tpm_tis_core.h
> index 6cc6b76..cd97c01 100644
> --- a/drivers/char/tpm/tpm_tis_core.h
> +++ b/drivers/char/tpm/tpm_tis_core.h
> @@ -107,6 +107,8 @@ struct tpm_tis_phy_ops {
>  	int (*read16)(struct tpm_tis_data *data, u32 addr, u16 *result);
>  	int (*read32)(struct tpm_tis_data *data, u32 addr, u32 *result);
>  	int (*write32)(struct tpm_tis_data *data, u32 addr, u32 src);
> +	bool (*verify_data_integrity)(struct tpm_tis_data *data, const u8 *buf,
> +				      size_t len);
>  };
>  
>  static inline int tpm_tis_read_bytes(struct tpm_tis_data *data, u32 addr,
> -- 
> 2.7.4
> 

As I've said before, I'm not too eager to add a new callback and nothing
in the commit message rationalizes adding one.

/Jarkko

  reply	other threads:[~2020-06-25 22:02 UTC|newest]

Thread overview: 15+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-06-25 14:46 [PATCH v12 0/9] Add tpm i2c ptp driver amirmizi6
2020-06-25 14:46 ` [PATCH v12 1/9] tpm: Make read{16, 32}() and write32() in tpm_tis_phy_ops optional amirmizi6
2020-06-25 14:46 ` [PATCH v12 2/9] tpm: tpm_tis: Fix expected bit handling and send all bytes in one shot without last byte in exception amirmizi6
2020-06-25 14:46 ` [PATCH v12 3/9] tpm: tpm_tis: Add retry in case of protocol failure amirmizi6
2020-06-25 22:00   ` Jarkko Sakkinen
2020-06-25 14:46 ` [PATCH v12 4/9] tpm: tpm_tis: Add verify_data_integrity handle to tpm_tis_phy_ops amirmizi6
2020-06-25 22:02   ` Jarkko Sakkinen [this message]
2020-06-25 14:46 ` [PATCH v12 5/9] tpm: tpm_tis: Rewrite "tpm_tis_req_canceled()" amirmizi6
2020-06-25 14:46 ` [PATCH v12 6/9] tpm: Handle an exception for TPM Firmware Update mode amirmizi6
2020-06-25 14:46 ` [PATCH v12 7/9] tpm: tpm_tis: verify TPM_STS register is valid after locality request amirmizi6
2020-06-25 17:12   ` kernel test robot
2020-06-25 18:59   ` kernel test robot
2020-06-25 14:46 ` [PATCH v12 8/9] tpm: Add YAML schema for TPM TIS I2C options amirmizi6
2020-06-25 14:46 ` [PATCH v12 9/9] tpm: tpm_tis: add tpm_tis_i2c driver amirmizi6
2020-06-28  4:20   ` kernel test robot

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200625220211.GJ20341@linux.intel.com \
    --to=jarkko.sakkinen@linux.intel.com \
    --cc=Dan.Morav@nuvoton.com \
    --cc=Eyal.Cohen@nuvoton.com \
    --cc=alexander.steffen@infineon.com \
    --cc=amir.mizinski@nuvoton.com \
    --cc=amirmizi6@gmail.com \
    --cc=arnd@arndb.de \
    --cc=christophe-h.ricard@st.com \
    --cc=christophe-h.richard@st.com \
    --cc=devicetree@vger.kernel.org \
    --cc=gcwilson@us.ibm.com \
    --cc=gregkh@linuxfoundation.org \
    --cc=jgg@ziepe.ca \
    --cc=kgoldman@us.ibm.com \
    --cc=linux-integrity@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=oren.tanami@nuvoton.com \
    --cc=oshri.alkoby@nuvoton.com \
    --cc=oshrialkoby85@gmail.com \
    --cc=peterhuewe@gmx.de \
    --cc=robh+dt@kernel.org \
    --cc=shmulik.hager@nuvoton.com \
    --cc=tmaimon77@gmail.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.