Re: [PATCH v4 2/2] MIPS: ingenic: Enable JZ4780_NEMC manually

[Thomas Bogendoerfer <tsbogend@alpha.franken.de>]

On Tue, Jul 28, 2020 at 02:00:35PM +0200, Krzysztof Kozlowski wrote:
> On Tue, Jul 28, 2020 at 01:37:02PM +0200, Thomas Bogendoerfer wrote:
> > On Tue, Jul 28, 2020 at 01:19:35PM +0200, Krzysztof Kozlowski wrote:
> > > On Tue, Jul 28, 2020 at 01:12:11PM +0200, Paul Cercueil wrote:
> > > > Hi Krzysztof,
> > > > 
> > > > Le mar. 28 juil. 2020 à 12:45, Krzysztof Kozlowski <krzk@kernel.org> a écrit
> > > > :
> > > > > The CONFIG_JZ4780_NEMC was previously a default on MIPS but now it has
> > > > > to be enabled manually.
> > > > > 
> > > > > Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
> > > > 
> > > > I think you should swap the two so that there are no problems when
> > > > bisecting.
> > > 
> > > Good point. I was thinking that it will go via some of MIPS trees and
> > > the patch #1 will just wait a cycle.  However with acks, I can take it
> > > through drivers/memory tree.
> > 
> > I've acked the patch.
> > 
> > Thomas.
> 
> Thanks but now I noticed that one of changed configs
> (arch/mips/configs/rs90_defconfig) is only in MIPS tree.
> 
> I think it is easier then to take the patch #2 (configs) via MIPS and
> wait with #1 for the next cycle or also take it via MIPS if it applies
> cleanly.

ok, I'll take it.

Thomas.

-- 
Crap can work. Given enough thrust pigs will fly, but it's not necessarily a
good idea.                                                [ RFC1925, 2.3 ]