[net V2 14/15] net/mlx5e: Fix VLAN create flow

[saeed@kernel.org]

From: Aya Levin <ayal@nvidia.com>

When interface is attached while in promiscuous mode and with VLAN
filtering turned off, both configurations are not respected and VLAN
filtering is performed.
There are 2 flows which add the any-vid rules during interface attach:
VLAN creation table and set rx mode. Each is relaying on the other to
add any-vid rules, eventually non of them does.

Fix this by adding any-vid rules on VLAN creation regardless of
promiscuous mode.

Fixes: 9df30601c843 ("net/mlx5e: Restore vlan filter after seamless reset")
Signed-off-by: Aya Levin <ayal@nvidia.com>
Reviewed-by: Moshe Shemesh <moshe@nvidia.com>
Signed-off-by: Saeed Mahameed <saeedm@nvidia.com>
---
 drivers/net/ethernet/mellanox/mlx5/core/en_fs.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/mellanox/mlx5/core/en_fs.c b/drivers/net/ethernet/mellanox/mlx5/core/en_fs.c
index 55a4c3adaa05..1f48f99c0997 100644
--- a/drivers/net/ethernet/mellanox/mlx5/core/en_fs.c
+++ b/drivers/net/ethernet/mellanox/mlx5/core/en_fs.c
@@ -217,6 +217,9 @@ static int __mlx5e_add_vlan_rule(struct mlx5e_priv *priv,
 		break;
 	}
 
+	if (WARN_ONCE(*rule_p, "VLAN rule already exists type %d", rule_type))
+		return 0;
+
 	*rule_p = mlx5_add_flow_rules(ft, spec, &flow_act, &dest, 1);
 
 	if (IS_ERR(*rule_p)) {
@@ -397,8 +400,7 @@ static void mlx5e_add_vlan_rules(struct mlx5e_priv *priv)
 	for_each_set_bit(i, priv->fs.vlan.active_svlans, VLAN_N_VID)
 		mlx5e_add_vlan_rule(priv, MLX5E_VLAN_RULE_TYPE_MATCH_STAG_VID, i);
 
-	if (priv->fs.vlan.cvlan_filter_disabled &&
-	    !(priv->netdev->flags & IFF_PROMISC))
+	if (priv->fs.vlan.cvlan_filter_disabled)
 		mlx5e_add_any_vid_rules(priv);
 }
 
-- 
2.26.2