[PATCH 1/2] usb: dwc3: gadget: Allow runtime suspend if UDC unbinded

[Wesley Cheng <wcheng@codeaurora.org>]

The DWC3 runtime suspend routine checks for the USB connected parameter to
determine if the controller can enter into a low power state.  The
connected state is only set to false after receiving a disconnect event.
However, in the case of a device initiated disconnect (i.e. UDC unbind),
the controller is halted and a disconnect event is never generated.  Set
the connected flag to false if issuing a device initiated disconnect to
allow the controller to be suspended.

Signed-off-by: Wesley Cheng <wcheng@codeaurora.org>
---
 drivers/usb/dwc3/gadget.c | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/drivers/usb/dwc3/gadget.c b/drivers/usb/dwc3/gadget.c
index 5d879b7606d5..6364429b2122 100644
--- a/drivers/usb/dwc3/gadget.c
+++ b/drivers/usb/dwc3/gadget.c
@@ -1995,6 +1995,11 @@ static int dwc3_gadget_pullup(struct usb_gadget *g, int is_on)
 	unsigned long		flags;
 	int			ret;
 
+	if (pm_runtime_suspended(dwc->dev)) {
+		pm_request_resume(dwc->dev);
+		return 0;
+	}
+
 	is_on = !!is_on;
 
 	/*
@@ -2050,6 +2055,7 @@ static int dwc3_gadget_pullup(struct usb_gadget *g, int is_on)
 			dwc->ev_buf->lpos = (dwc->ev_buf->lpos + count) %
 						dwc->ev_buf->length;
 		}
+		dwc->connected = false;
 	}
 
 	ret = dwc3_gadget_run_stop(dwc, is_on, false);
-- 
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project