[PATCH v1 2/2] pinctrl: lynxpoint: Enable pin configuration setting for GPIO chip

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

It appears that pin configuration for GPIO chip hasn't been enabled yet
due to absence of ->set_config() callback.

Enable it here for Intel Lynxpoint PCH.

Depends-on: 2956b5d94a76 ("pinctrl / gpio: Introduce .set_config() callback for GPIO chips")
Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
 drivers/pinctrl/intel/pinctrl-lynxpoint.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/pinctrl/intel/pinctrl-lynxpoint.c b/drivers/pinctrl/intel/pinctrl-lynxpoint.c
index 2e9670fc479a..0a48ca46ab59 100644
--- a/drivers/pinctrl/intel/pinctrl-lynxpoint.c
+++ b/drivers/pinctrl/intel/pinctrl-lynxpoint.c
@@ -874,6 +874,7 @@ static int lp_gpio_probe(struct platform_device *pdev)
 	gc->direction_output = lp_gpio_direction_output;
 	gc->get = lp_gpio_get;
 	gc->set = lp_gpio_set;
+	gc->set_config = gpiochip_generic_config;
 	gc->get_direction = lp_gpio_get_direction;
 	gc->base = -1;
 	gc->ngpio = LP_NUM_GPIO;
-- 
2.28.0