Re: [PATCH v4 5/8] maintenance: add start/stop subcommands

[Josh Steadmon <steadmon@google.com>]

Whoops, had a small think-o while writing the patch message. Fixed
below.

-- >8 --
Subject: [PATCH] t7900: use --fixed-value in git-maintenance tests

Use --fixed-value in git-config calls in the git-maintenance tests, so
that the tests will continue to work even if the repo path contains
regexp metacharacters.

Signed-off-by: Josh Steadmon <steadmon@google.com>
---
 t/t7900-maintenance.sh | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/t/t7900-maintenance.sh b/t/t7900-maintenance.sh
index fab0e01c39..41bf523953 100755
--- a/t/t7900-maintenance.sh
+++ b/t/t7900-maintenance.sh
@@ -422,7 +422,7 @@ test_expect_success 'start from empty cron table' '
 	GIT_TEST_CRONTAB="test-tool crontab cron.txt" git maintenance start &&
 
 	# start registers the repo
-	git config --get --global maintenance.repo "$(pwd)" &&
+	git config --get --global --fixed-value maintenance.repo "$(pwd)" &&
 
 	grep "for-each-repo --config=maintenance.repo maintenance run --schedule=daily" cron.txt &&
 	grep "for-each-repo --config=maintenance.repo maintenance run --schedule=hourly" cron.txt &&
@@ -433,7 +433,7 @@ test_expect_success 'stop from existing schedule' '
 	GIT_TEST_CRONTAB="test-tool crontab cron.txt" git maintenance stop &&
 
 	# stop does not unregister the repo
-	git config --get --global maintenance.repo "$(pwd)" &&
+	git config --get --global --fixed-value maintenance.repo "$(pwd)" &&
 
 	# Operation is idempotent
 	GIT_TEST_CRONTAB="test-tool crontab cron.txt" git maintenance stop &&
-- 
2.29.2.576.ga3fc446d84-goog