Re: [PATCH 2/4] clk: qcom: clk-rcg2: Make sure to not write d=0 to the NMD register

[Stephen Boyd <sboyd@kernel.org>]

Quoting Nikita Travkin (2021-12-09 08:37:18)
> Sometimes calculation of d value may result in 0 because of the
> rounding after integer division. This causes the following error:
> 
> [  113.969689] camss_gp1_clk_src: rcg didn't update its configuration.
> [  113.969754] WARNING: CPU: 3 PID: 35 at drivers/clk/qcom/clk-rcg2.c:122 update_config+0xc8/0xdc
> 
> Make sure that D value is never zero.
> 
> Fixes: 7f891faf596e ("clk: qcom: clk-rcg2: Add support for duty-cycle for RCG")
> Signed-off-by: Nikita Travkin <nikita@trvn.ru>
> ---
>  drivers/clk/qcom/clk-rcg2.c | 4 ++++
>  1 file changed, 4 insertions(+)
> 
> diff --git a/drivers/clk/qcom/clk-rcg2.c b/drivers/clk/qcom/clk-rcg2.c
> index 6964cf914b60..fdfd43e2a01b 100644
> --- a/drivers/clk/qcom/clk-rcg2.c
> +++ b/drivers/clk/qcom/clk-rcg2.c
> @@ -424,6 +424,10 @@ static int clk_rcg2_set_duty_cycle(struct clk_hw *hw, struct clk_duty *duty)
>         if (d > mask)
>                 d = mask;
>  
> +       /* Hardware can't handle d=0, make sure it's at least 1 */
> +       if (!d)
> +               d = 1;

Maybe clamp() would be better

	/*
 	 * Check bit widths of 2d. If D is too big reduce duty cycle and
	 * ensure it is non-zero.
	 */
	clamp(d, 1, mask);

> +
>         if ((d / 2) > (n - m))
>                 d = (n - m) * 2;
>         else if ((d / 2) < (m / 2))