[PATCH 2/3] drivers: i2c: thunderx: Add support for High speed mode

[Piyush Malgujar <pmalgujar@marvell.com>]

Support High speed mode clock setup for OcteonTX2 platforms.

Signed-off-by: Suneel Garapati <sgarapati@marvell.com>
Signed-off-by: Piyush Malgujar <pmalgujar@marvell.com>
---
 drivers/i2c/busses/i2c-octeon-core.c     | 64 +++++++++++++++---------
 drivers/i2c/busses/i2c-octeon-core.h     |  3 ++
 drivers/i2c/busses/i2c-thunderx-pcidrv.c |  3 +-
 3 files changed, 46 insertions(+), 24 deletions(-)

diff --git a/drivers/i2c/busses/i2c-octeon-core.c b/drivers/i2c/busses/i2c-octeon-core.c
index 49d07a63a01f0b0711f4fa7a5d13d684935e5cbc..1588d9186b198bfe6ae78626829b3f221d51b8d9 100644
--- a/drivers/i2c/busses/i2c-octeon-core.c
+++ b/drivers/i2c/busses/i2c-octeon-core.c
@@ -608,25 +608,27 @@ int octeon_i2c_xfer(struct i2c_adapter *adap, struct i2c_msg *msgs, int num)
 	struct octeon_i2c *i2c = i2c_get_adapdata(adap);
 	int i, ret = 0;
 
-	if (num == 1) {
-		if (msgs[0].len > 0 && msgs[0].len <= 8) {
-			if (msgs[0].flags & I2C_M_RD)
-				ret = octeon_i2c_hlc_read(i2c, msgs);
-			else
-				ret = octeon_i2c_hlc_write(i2c, msgs);
-			goto out;
-		}
-	} else if (num == 2) {
-		if ((msgs[0].flags & I2C_M_RD) == 0 &&
-		    (msgs[1].flags & I2C_M_RECV_LEN) == 0 &&
-		    msgs[0].len > 0 && msgs[0].len <= 2 &&
-		    msgs[1].len > 0 && msgs[1].len <= 8 &&
-		    msgs[0].addr == msgs[1].addr) {
-			if (msgs[1].flags & I2C_M_RD)
-				ret = octeon_i2c_hlc_comp_read(i2c, msgs);
-			else
-				ret = octeon_i2c_hlc_comp_write(i2c, msgs);
-			goto out;
+	if (IS_LS_FREQ(i2c->twsi_freq)) {
+		if (num == 1) {
+			if (msgs[0].len > 0 && msgs[0].len <= 8) {
+				if (msgs[0].flags & I2C_M_RD)
+					ret = octeon_i2c_hlc_read(i2c, msgs);
+				else
+					ret = octeon_i2c_hlc_write(i2c, msgs);
+				goto out;
+			}
+		} else if (num == 2) {
+			if ((msgs[0].flags & I2C_M_RD) == 0 &&
+			    (msgs[1].flags & I2C_M_RECV_LEN) == 0 &&
+			    msgs[0].len > 0 && msgs[0].len <= 2 &&
+			    msgs[1].len > 0 && msgs[1].len <= 8 &&
+			    msgs[0].addr == msgs[1].addr) {
+				if (msgs[1].flags & I2C_M_RD)
+					ret = octeon_i2c_hlc_comp_read(i2c, msgs);
+				else
+					ret = octeon_i2c_hlc_comp_write(i2c, msgs);
+				goto out;
+			}
 		}
 	}
 
@@ -665,10 +667,13 @@ void octeon_i2c_set_clock(struct octeon_i2c *i2c)
 	 * Find divisors to produce target frequency, start with large delta
 	 * to cover wider range of divisors, note thp = TCLK half period.
 	 */
-	int thp = 0x18, mdiv = 2, ndiv = 0, delta_hz = huge_delta;
+	int ds = 10, thp = 0x18, mdiv = 2, ndiv = 0, delta_hz = huge_delta;
 
-	if (octeon_i2c_is_otx2(to_pci_dev(i2c->dev)))
+	if (octeon_i2c_is_otx2(to_pci_dev(i2c->dev))) {
 		thp = 0x3;
+		if (!IS_LS_FREQ(i2c->twsi_freq))
+			ds = 15;
+	}
 
 	for (ndiv_idx = 0; ndiv_idx < 8 && delta_hz != 0; ndiv_idx++) {
 		/*
@@ -680,7 +685,7 @@ void octeon_i2c_set_clock(struct octeon_i2c *i2c)
 			 * For given ndiv and mdiv values check the
 			 * two closest thp values.
 			 */
-			tclk = i2c->twsi_freq * (mdiv_idx + 1) * 10;
+			tclk = i2c->twsi_freq * (mdiv_idx + 1) * ds;
 			tclk *= (1 << ndiv_idx);
 			if (octeon_i2c_is_otx2(to_pci_dev(i2c->dev)))
 				thp_base = (i2c->sys_freq / tclk) - 2;
@@ -698,7 +703,9 @@ void octeon_i2c_set_clock(struct octeon_i2c *i2c)
 					foscl = i2c->sys_freq /
 						(2 * (thp_idx + 1));
 				foscl = foscl / (1 << ndiv_idx);
-				foscl = foscl / (mdiv_idx + 1) / 10;
+				foscl = foscl / (mdiv_idx + 1) / ds;
+				if (foscl > i2c->twsi_freq)
+					continue;
 				diff = abs(foscl - i2c->twsi_freq);
 				/* Use it if smaller diff from target */
 				if (diff < delta_hz) {
@@ -712,6 +719,17 @@ void octeon_i2c_set_clock(struct octeon_i2c *i2c)
 	}
 	octeon_i2c_reg_write(i2c, SW_TWSI_OP_TWSI_CLK, thp);
 	octeon_i2c_reg_write(i2c, SW_TWSI_EOP_TWSI_CLKCTL, (mdiv << 3) | ndiv);
+	if (octeon_i2c_is_otx2(to_pci_dev(i2c->dev))) {
+		u64 mode;
+
+		mode = __raw_readq(i2c->twsi_base + MODE(i2c));
+		/* Set REFCLK_SRC and HS_MODE in TWSX_MODE register */
+		if (!IS_LS_FREQ(i2c->twsi_freq))
+			mode |= BIT(4) | BIT(0);
+		else
+			mode &= ~(BIT(4) | BIT(0));
+		octeon_i2c_writeq_flush(mode, i2c->twsi_base + MODE(i2c));
+	}
 }
 
 int octeon_i2c_init_lowlevel(struct octeon_i2c *i2c)
diff --git a/drivers/i2c/busses/i2c-octeon-core.h b/drivers/i2c/busses/i2c-octeon-core.h
index 15d379bf1d3cbba78378edfb6d45415a31ab4072..6a6c7c22c8bace850b9716a96a7d66827268f469 100644
--- a/drivers/i2c/busses/i2c-octeon-core.h
+++ b/drivers/i2c/busses/i2c-octeon-core.h
@@ -92,11 +92,13 @@ struct octeon_i2c_reg_offset {
 	unsigned int sw_twsi;
 	unsigned int twsi_int;
 	unsigned int sw_twsi_ext;
+	unsigned int mode;
 };
 
 #define SW_TWSI(x)	(x->roff.sw_twsi)
 #define TWSI_INT(x)	(x->roff.twsi_int)
 #define SW_TWSI_EXT(x)	(x->roff.sw_twsi_ext)
+#define MODE(x)		(x->roff.mode)
 
 struct octeon_i2c {
 	wait_queue_head_t queue;
@@ -211,6 +213,7 @@ static inline void octeon_i2c_write_int(struct octeon_i2c *i2c, u64 data)
 	octeon_i2c_writeq_flush(data, i2c->twsi_base + TWSI_INT(i2c));
 }
 
+#define IS_LS_FREQ(twsi_freq) ((twsi_freq) <= 400000)
 #define PCI_SUBSYS_DEVID_9XXX 0xB
 /**
  * octeon_i2c_is_otx2 - check for chip ID
diff --git a/drivers/i2c/busses/i2c-thunderx-pcidrv.c b/drivers/i2c/busses/i2c-thunderx-pcidrv.c
index 9fd903196b6cf967cde321da04f8d0526d84cc2f..5621e983406b0bebf9c5c9e30921e45f3f15909b 100644
--- a/drivers/i2c/busses/i2c-thunderx-pcidrv.c
+++ b/drivers/i2c/busses/i2c-thunderx-pcidrv.c
@@ -165,6 +165,7 @@ static int thunder_i2c_probe_pci(struct pci_dev *pdev,
 	i2c->roff.sw_twsi = 0x1000;
 	i2c->roff.twsi_int = 0x1010;
 	i2c->roff.sw_twsi_ext = 0x1018;
+	i2c->roff.mode = 0x1038;
 
 	i2c->dev = dev;
 	pci_set_drvdata(pdev, i2c);
@@ -209,7 +210,7 @@ static int thunder_i2c_probe_pci(struct pci_dev *pdev,
 	 * For OcteonTX2 chips, set reference frequency to 100MHz
 	 * as refclk_src in TWSI_MODE register defaults to 100MHz.
 	 */
-	if (octeon_i2c_is_otx2(pdev))
+	if (octeon_i2c_is_otx2(pdev) && IS_LS_FREQ(i2c->twsi_freq))
 		i2c->sys_freq = 100000000;
 	octeon_i2c_set_clock(i2c);
 
-- 
2.17.1