Re: [PATCH v2] PCI: qcom: Allow L1 and its sub states

[Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>]

On Wed, Jun 15, 2022 at 06:45:39PM +0530, Krishna chaitanya chundru wrote:
> Allow L1 and its sub-states in the qcom pcie driver.
> By default this is disabled in the hardware. So enabling it explicitly.
> 

You are enabling L1ss for controllers belonging to 2_7_0, so this should
be mentioned in the commit message. Otherwise, it will imply that the
L1ss is added for all controller versions.

> Signed-off-by: Krishna chaitanya chundru <quic_krichai@quicinc.com>
> ---

Change log should be added here for versions > 1.

Thanks,
Mani

>  drivers/pci/controller/dwc/pcie-qcom.c | 8 ++++++++
>  1 file changed, 8 insertions(+)
> 
> diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
> index 6ab9089..0d8efcc 100644
> --- a/drivers/pci/controller/dwc/pcie-qcom.c
> +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> @@ -41,6 +41,9 @@
>  #define L23_CLK_RMV_DIS				BIT(2)
>  #define L1_CLK_RMV_DIS				BIT(1)
>  
> +#define PCIE20_PARF_PM_CTRL			0x20
> +#define REQ_NOT_ENTR_L1				BIT(5)
> +
>  #define PCIE20_PARF_PHY_CTRL			0x40
>  #define PHY_CTRL_PHY_TX0_TERM_OFFSET_MASK	GENMASK(20, 16)
>  #define PHY_CTRL_PHY_TX0_TERM_OFFSET(x)		((x) << 16)
> @@ -1267,6 +1270,11 @@ static int qcom_pcie_init_2_7_0(struct qcom_pcie *pcie)
>  	val |= BIT(4);
>  	writel(val, pcie->parf + PCIE20_PARF_MHI_CLOCK_RESET_CTRL);
>  
> +	/* Enable L1 and L1ss */
> +	val = readl(pcie->parf + PCIE20_PARF_PM_CTRL);
> +	val &= ~REQ_NOT_ENTR_L1;
> +	writel(val, pcie->parf + PCIE20_PARF_PM_CTRL);
> +
>  	if (IS_ENABLED(CONFIG_PCI_MSI)) {
>  		val = readl(pcie->parf + PCIE20_PARF_AXI_MSTR_WR_ADDR_HALT);
>  		val |= BIT(31);
> -- 
> 2.7.4
>