Re: [PATCH v2 02/10] dt-bindings: iio: accel: use spi-peripheral-props.yaml

[Rob Herring <robh@kernel.org>]

On Sun, Jul 31, 2022 at 04:49:43PM +0100, Jonathan Cameron wrote:
> On Wed, 27 Jul 2022 18:46:38 +0200
> Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> wrote:
> 
> > Instead of listing directly properties typical for SPI peripherals,
> > reference the spi-peripheral-props.yaml schema.  This allows using all
> > properties typical for SPI-connected devices, even these which device
> > bindings author did not tried yet.
> > 
> > Remove the spi-* properties which now come via spi-peripheral-props.yaml
> > schema, except for the cases when device schema adds some constraints
> > like maximum frequency.
> > 
> > While changing additionalProperties->unevaluatedProperties, put it in
> > typical place, just before example DTS.
> > 
> > Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
> > 
> > ---
> > 
> > I wonder if spi-3wire is device specific (not controller) and should be
> > rather explicitly mentioned by device schema. Just like spi-cpol/cpha.
> 
> I think it is, but Mark is expert on this.

I would say yes as it's the device with a single data line.

> In general I'm waiting on Mark's opinion on the whole idea!

The prerequisite changes (except for spi-3-wire) are already queued up 
by Mark as are changes for other subsystems.

Rob