[PATCH v5 12/14] tty: serial: qcom-geni-serial: stop operations in progress at shutdown

[Bartosz Golaszewski <brgl@bgdev.pl>]

From: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

We don't stop transmissions in progress at shutdown. This is fine with
FIFO SE mode but with DMA it causes trouble so fix it now.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
---
 drivers/tty/serial/qcom_geni_serial.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
index 808b0250d51e..1dfc0122ff53 100644
--- a/drivers/tty/serial/qcom_geni_serial.c
+++ b/drivers/tty/serial/qcom_geni_serial.c
@@ -864,6 +864,8 @@ static void get_tx_fifo_size(struct qcom_geni_serial_port *port)
 static void qcom_geni_serial_shutdown(struct uart_port *uport)
 {
 	disable_irq(uport->irq);
+	qcom_geni_serial_stop_tx(uport);
+	qcom_geni_serial_stop_rx(uport);
 }
 
 static int qcom_geni_serial_port_setup(struct uart_port *uport)
-- 
2.37.2