Re: [PATCH 2/2] dt-bindings: net: phy: vsc8531: document 'vsc8531,clkout-freq-mhz' property

[Rob Herring <robh@kernel.org>]

On Thu, Jul 06, 2023 at 11:15:54AM +0300, Alexandru Ardelean wrote:
> For VSC8351 and similar PHYs, a new property was added to generate a clock
> signal on the CLKOUT pin.
> This change documents the change in the device-tree bindings doc.
> 
> Signed-off-by: Alexandru Ardelean <alex@shruggie.ro>
> ---
>  Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt | 5 +++++
>  1 file changed, 5 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt b/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt
> index 0a3647fe331b..133bdd644618 100644
> --- a/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt
> +++ b/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt
> @@ -31,6 +31,10 @@ Optional properties:
>  			  VSC8531_LINK_100_ACTIVITY (2),
>  			  VSC8531_LINK_ACTIVITY (0) and
>  			  VSC8531_DUPLEX_COLLISION (8).
> +- vsc8531,clkout-freq-mhz : For VSC8531 and similar PHYs, this will output

Please don't continue this naming pattern with 'vsc8531' prefix. The 
prefix should be the vendor prefix.

> +			  a clock signal on the CLKOUT pin of the chip.
> +			  The supported values are 25, 50 & 125 Mhz.
> +			  Default value is no clock signal on the CLKOUT pin.
>  - load-save-gpios	: GPIO used for the load/save operation of the PTP
>  			  hardware clock (PHC).
>  
> @@ -69,5 +73,6 @@ Example:
>                  vsc8531,edge-slowdown	= <7>;
>                  vsc8531,led-0-mode	= <VSC8531_LINK_1000_ACTIVITY>;
>                  vsc8531,led-1-mode	= <VSC8531_LINK_100_ACTIVITY>;
> +                vsc8531,clkout-freq-mhz	= <50>;
>  		load-save-gpios		= <&gpio 10 GPIO_ACTIVE_HIGH>;
>          };
> -- 
> 2.40.1
>