Re: [PATCH v18 05/20] PCI: dwc: Add outbound MSG TLPs support

[Manivannan Sadhasivam <mani@kernel.org>]

On Fri, Jul 21, 2023 at 04:44:37PM +0900, Yoshihiro Shimoda wrote:
> Add "code" and "routing" into struct dw_pcie_ob_atu_cfg for sending
> MSG by iATU in the PCIe endpoint mode in near the future.

It's better to specify the exact requirement here "triggering INTx IRQs"
instead of implying.

> PCIE_ATU_INHIBIT_PAYLOAD is set to issue TLP type of Msg instead of
> MsgD. So, this implementation supports the data-less messages only
> for now.
> 
> Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>

Same comment for patch 4/20 applies here also. With that fixed,

Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>

- Mani

> Reviewed-by: Serge Semin <fancer.lancer@gmail.com>
> ---
>  drivers/pci/controller/dwc/pcie-designware.c | 9 +++++++--
>  drivers/pci/controller/dwc/pcie-designware.h | 4 ++++
>  2 files changed, 11 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/pci/controller/dwc/pcie-designware.c b/drivers/pci/controller/dwc/pcie-designware.c
> index 49b785509576..2d0f816fa0ab 100644
> --- a/drivers/pci/controller/dwc/pcie-designware.c
> +++ b/drivers/pci/controller/dwc/pcie-designware.c
> @@ -498,7 +498,7 @@ int dw_pcie_prog_outbound_atu(struct dw_pcie *pci,
>  	dw_pcie_writel_atu_ob(pci, atu->index, PCIE_ATU_UPPER_TARGET,
>  			      upper_32_bits(atu->pci_addr));
>  
> -	val = atu->type | PCIE_ATU_FUNC_NUM(atu->func_no);
> +	val = atu->type | atu->routing | PCIE_ATU_FUNC_NUM(atu->func_no);
>  	if (upper_32_bits(limit_addr) > upper_32_bits(cpu_addr) &&
>  	    dw_pcie_ver_is_ge(pci, 460A))
>  		val |= PCIE_ATU_INCREASE_REGION_SIZE;
> @@ -506,7 +506,12 @@ int dw_pcie_prog_outbound_atu(struct dw_pcie *pci,
>  		val = dw_pcie_enable_ecrc(val);
>  	dw_pcie_writel_atu_ob(pci, atu->index, PCIE_ATU_REGION_CTRL1, val);
>  
> -	dw_pcie_writel_atu_ob(pci, atu->index, PCIE_ATU_REGION_CTRL2, PCIE_ATU_ENABLE);
> +	val = PCIE_ATU_ENABLE;
> +	if (atu->type == PCIE_ATU_TYPE_MSG) {
> +		/* The data-less messages only for now */
> +		val |= PCIE_ATU_INHIBIT_PAYLOAD | atu->code;
> +	}
> +	dw_pcie_writel_atu_ob(pci, atu->index, PCIE_ATU_REGION_CTRL2, val);
>  
>  	/*
>  	 * Make sure ATU enable takes effect before any subsequent config
> diff --git a/drivers/pci/controller/dwc/pcie-designware.h b/drivers/pci/controller/dwc/pcie-designware.h
> index 85de0d8346fa..c626d21243b0 100644
> --- a/drivers/pci/controller/dwc/pcie-designware.h
> +++ b/drivers/pci/controller/dwc/pcie-designware.h
> @@ -147,11 +147,13 @@
>  #define PCIE_ATU_TYPE_IO		0x2
>  #define PCIE_ATU_TYPE_CFG0		0x4
>  #define PCIE_ATU_TYPE_CFG1		0x5
> +#define PCIE_ATU_TYPE_MSG		0x10
>  #define PCIE_ATU_TD			BIT(8)
>  #define PCIE_ATU_FUNC_NUM(pf)           ((pf) << 20)
>  #define PCIE_ATU_REGION_CTRL2		0x004
>  #define PCIE_ATU_ENABLE			BIT(31)
>  #define PCIE_ATU_BAR_MODE_ENABLE	BIT(30)
> +#define PCIE_ATU_INHIBIT_PAYLOAD	BIT(22)
>  #define PCIE_ATU_FUNC_NUM_MATCH_EN      BIT(19)
>  #define PCIE_ATU_LOWER_BASE		0x008
>  #define PCIE_ATU_UPPER_BASE		0x00C
> @@ -292,6 +294,8 @@ struct dw_pcie_ob_atu_cfg {
>  	int index;
>  	int type;
>  	u8 func_no;
> +	u8 code;
> +	u8 routing;
>  	u64 cpu_addr;
>  	u64 pci_addr;
>  	u64 size;
> -- 
> 2.25.1
> 

-- 
மணிவண்ணன் சதாசிவம்