[PATCH v5 2/4] arm64: dts: qcom: pm6150: Add resin and rtc nodes

[David Wronek <davidwronek@gmail.com>]

Add support for the RTC which is the same as on other PMICs and add the
resin child node to the PM6150 PON device, both disabled by default.

Signed-off-by: David Wronek <davidwronek@gmail.com>
Tested-by: Nikita Travkin <nikita@trvn.ru>
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
---
 arch/arm64/boot/dts/qcom/pm6150.dtsi | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/pm6150.dtsi b/arch/arm64/boot/dts/qcom/pm6150.dtsi
index 7d4d1f2767ed..ddbaf7280b03 100644
--- a/arch/arm64/boot/dts/qcom/pm6150.dtsi
+++ b/arch/arm64/boot/dts/qcom/pm6150.dtsi
@@ -53,6 +53,14 @@ pm6150_pwrkey: pwrkey {
 				bias-pull-up;
 				linux,code = <KEY_POWER>;
 			};
+
+			pm6150_resin: resin {
+				compatible = "qcom,pm8941-resin";
+				interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
+				debounce = <15625>;
+				bias-pull-up;
+				status = "disabled";
+			};
 		};
 
 		pm6150_temp: temp-alarm@2400 {
@@ -88,6 +96,14 @@ pm6150_adc_tm: adc-tm@3500 {
 			status = "disabled";
 		};
 
+		pm6150_rtc: rtc@6000 {
+			compatible = "qcom,pm8941-rtc";
+			reg = <0x6000>, <0x6100>;
+			reg-names = "rtc", "alarm";
+			interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
+			status = "disabled";
+		};
+
 		pm6150_gpios: gpio@c000 {
 			compatible = "qcom,pm6150-gpio", "qcom,spmi-gpio";
 			reg = <0xc000>;
-- 
2.42.0