Re: [PATCH v14 3/9] dt-bindings: soc: qcom: cpr3: Add bindings for CPR3 driver

[Rob Herring <robh@kernel.org>]

On Tue, Aug 29, 2023 at 01:01:44PM +0200, Ulf Hansson wrote:
> On Mon, 28 Aug 2023 at 13:42, Konrad Dybcio <konrad.dybcio@linaro.org> wrote:
> >
> > From: AngeloGioacchino Del Regno <angelogioacchino.delregno@somainline.org>
> >
> > Add the bindings for the CPR3 driver to the documentation.
> >
> > Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@somainline.org>
> > [Konrad: Make binding check pass; update AGdR's email]
> > Tested-by: Jeffrey Hugo <quic_jhugo@quicinc.com>
> > Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org>
> > ---
> >  .../devicetree/bindings/soc/qcom/qcom,cpr3.yaml    | 286 +++++++++++++++++++++
> >  1 file changed, 286 insertions(+)
> >
> > diff --git a/Documentation/devicetree/bindings/soc/qcom/qcom,cpr3.yaml b/Documentation/devicetree/bindings/soc/qcom/qcom,cpr3.yaml
> > new file mode 100644
> > index 000000000000..acf2e294866b
> 
> [...]
> 
> > +
> > +examples:
> > +  - |
> > +    #include <dt-bindings/clock/qcom,gcc-msm8998.h>
> > +    #include <dt-bindings/interrupt-controller/irq.h>
> > +
> > +    cpus {
> > +        #address-cells = <2>;
> > +        #size-cells = <0>;
> > +
> > +        cpu@0 {
> > +            compatible = "qcom,kryo280";
> > +            device_type = "cpu";
> > +            reg = <0x0 0x0>;
> > +            operating-points-v2 = <&cpu0_opp_table>;
> > +            power-domains = <&apc_cprh 0>;
> > +            power-domain-names = "cprh";
> 
> Rather than using a Qcom specific power-domain-name, perhaps a common
> power-domain-name for cpus, that can be used for "the performance
> domain" would be a good idea here?
> 
> I have suggested using "perf" for the SCMI performance domain [1],
> perhaps that description should be extended to cover this and other
> performance domains too?

Better yet, nothing. There's no value to -names when there is only 1 
entry.

Rob