[PATCH net 3/3] amd-xgbe: propagate the correct speed and duplex status

[Raju Rangoju <Raju.Rangoju@amd.com>]

xgbe_get_link_ksettings() does not propagate correct speed and duplex
information to ethtool during cable unplug. Due to which ethtool reports
incorrect values for speed and duplex.

Address this by propagating correct information.

Fixes: 7c12aa08779c ("amd-xgbe: Move the PHY support into amd-xgbe")
Acked-by: Shyam Sundar S K <Shyam-sundar.S-k@amd.com>
Signed-off-by: Raju Rangoju <Raju.Rangoju@amd.com>
---
 drivers/net/ethernet/amd/xgbe/xgbe-ethtool.c | 11 ++++++++---
 1 file changed, 8 insertions(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/amd/xgbe/xgbe-ethtool.c b/drivers/net/ethernet/amd/xgbe/xgbe-ethtool.c
index 6e83ff59172a..32fab5e77246 100644
--- a/drivers/net/ethernet/amd/xgbe/xgbe-ethtool.c
+++ b/drivers/net/ethernet/amd/xgbe/xgbe-ethtool.c
@@ -314,10 +314,15 @@ static int xgbe_get_link_ksettings(struct net_device *netdev,
 
 	cmd->base.phy_address = pdata->phy.address;
 
-	cmd->base.autoneg = pdata->phy.autoneg;
-	cmd->base.speed = pdata->phy.speed;
-	cmd->base.duplex = pdata->phy.duplex;
+	if (netif_carrier_ok(netdev)) {
+		cmd->base.speed = pdata->phy.speed;
+		cmd->base.duplex = pdata->phy.duplex;
+	} else {
+		cmd->base.speed = SPEED_UNKNOWN;
+		cmd->base.duplex = DUPLEX_UNKNOWN;
+	}
 
+	cmd->base.autoneg = pdata->phy.autoneg;
 	cmd->base.port = PORT_NONE;
 
 	XGBE_LM_COPY(cmd, supported, lks, supported);
-- 
2.25.1