[PATCH 2/2] Bluetooth: qca: run the power-on/off sequence for QCA6390 too

[Bartosz Golaszewski <brgl@bgdev.pl>]

From: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>

The Bluetooth module on QCA6390 needs to be powered-on by enabling the
relevant regulators and driving the enable GPIO high. We can reuse the
power sequence for the WNC models.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
---
 drivers/bluetooth/hci_qca.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 7f25931a946e..351ba904c8c2 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -1788,6 +1788,7 @@ static int qca_power_on(struct hci_dev *hdev)
 	case QCA_WCN6750:
 	case QCA_WCN6855:
 	case QCA_WCN7850:
+	case QCA_QCA6390:
 		ret = qca_regulator_init(hu);
 		break;
 
@@ -2137,6 +2138,7 @@ static void qca_power_shutdown(struct hci_uart *hu)
 
 	case QCA_WCN6750:
 	case QCA_WCN6855:
+	case QCA_QCA6390:
 		gpiod_set_value_cansleep(qcadev->bt_en, 0);
 		msleep(100);
 		qca_regulator_disable(qcadev);
@@ -2284,6 +2286,7 @@ static int qca_serdev_probe(struct serdev_device *serdev)
 	case QCA_WCN6750:
 	case QCA_WCN6855:
 	case QCA_WCN7850:
+	case QCA_QCA6390:
 		qcadev->bt_power = devm_kzalloc(&serdev->dev,
 						sizeof(struct qca_power),
 						GFP_KERNEL);
@@ -2394,6 +2397,7 @@ static void qca_serdev_remove(struct serdev_device *serdev)
 	case QCA_WCN6750:
 	case QCA_WCN6855:
 	case QCA_WCN7850:
+	case QCA_QCA6390:
 		if (power->vregs_on) {
 			qca_power_shutdown(&qcadev->serdev_hu);
 			break;
-- 
2.40.1