Re: [PATCH v13 1/3] dt-bindings: adc: add AD7173

[Jonathan Cameron <jic23@kernel.org>]

On Tue, 20 Feb 2024 18:52:37 +0000
Conor Dooley <conor@kernel.org> wrote:

> On Tue, Feb 20, 2024 at 11:43:38AM +0200, Dumitru Ceclan wrote:
> 
> > +  interrupts:
> > +    minItems: 1
> > +    description: |  
> 
> > +
> > +  interrupt-names:
> > +    minItems: 1
> > +    items:
> > +      - const: rdy
> > +      - const: err  
> 
> I noticed that for minItems == 1, the rdy interrupt is required and err
> is the optional one.
> 
> With that in mind, you can simplify the interrupts description so that
> it describes the interrupts separately:
> 
>   interrupts:
>     minItems:
>     items:
>       - description:
>           Ready: multiplexed with SPI data out. While SPI CS is low,
>           can be used to indicate the completion of a conversion.
> 
>       - description:
>           Error: The three error bits in the status register (ADC_ERROR, CRC_ERROR,
>           and REG_ERROR) are OR'ed, inverted, and mapped to the ERROR pin. Therefore,
>           the ERROR pin indicates that an error has occurred.
> 
> Otherwise, I think everything has been sorted out?
> 
> Reviewed-by: Conor Dooley <conor.dooley@microchip.com>

This ordering may bite us in the future. Someone will build a board
with err as only one wired. But meh, it will be a binding relaxation needed
so I'm not that bothered by that.
> 
> Cheers,
> Conor.