Re: [PATCH net-next v10 6/6] net: stmmac: dwmac-loongson: Add Loongson GNET support

[Simon Horman <horms@kernel.org>]

On Tue, Apr 09, 2024 at 10:04:34PM +0800, Yanteng Si wrote:

...

> diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-loongson.c

...

> @@ -145,42 +568,37 @@ static int loongson_dwmac_probe(struct pci_dev *pdev, const struct pci_device_id
>  			goto err_disable_device;
>  		}
>  		plat->phy_interface = phy_mode;
> -
> -		res.irq = of_irq_get_byname(np, "macirq");
> -		if (res.irq < 0) {
> -			dev_err(&pdev->dev, "IRQ macirq not found\n");
> -			ret = -ENODEV;
> -			goto err_disable_msi;
> -		}
> -
> -		res.wol_irq = of_irq_get_byname(np, "eth_wake_irq");
> -		if (res.wol_irq < 0) {
> -			dev_info(&pdev->dev, "IRQ eth_wake_irq not found, using macirq\n");
> -			res.wol_irq = res.irq;
> -		}
> -
> -		res.lpi_irq = of_irq_get_byname(np, "eth_lpi");
> -		if (res.lpi_irq < 0) {
> -			dev_err(&pdev->dev, "IRQ eth_lpi not found\n");
> -			ret = -ENODEV;
> -			goto err_disable_msi;
> -		}
> -	} else {
> -		res.irq = pdev->irq;
>  	}
>  
> -	pci_enable_msi(pdev);
>  	memset(&res, 0, sizeof(res));
>  	res.addr = pcim_iomap_table(pdev)[0];
>  
> +	ld->dev = &pdev->dev;
> +	plat->bsp_priv = ld;
> +	loongson_gmac = readl(res.addr + GMAC_VERSION) & 0xff;
> +
> +	switch (loongson_gmac) {
> +	case LOONGSON_DWMAC_CORE_1_00:
> +		plat->setup = loongson_gnet_setup;
> +		/* Only channel 0 of the 0x10 device supports checksum,
> +		 * so turn off checksum to enable multiple channels.
> +		 */
> +		for (i = 1; i < CHANNEL_NUM; i++) {
> +			plat->tx_queues_cfg[i].coe_unsupported = 1;
> +		};

nit: '}' rather than '};'

> +		ret = loongson_dwmac_config_msi(pdev, plat, &res, np);
> +		break;
> +	default:	/* 0x35 device and 0x37 device. */
> +		ret = loongson_dwmac_config_legacy(pdev, plat, &res, np);
> +		break;
> +	}
> +
>  	ret = stmmac_dvr_probe(&pdev->dev, plat, &res);
>  	if (ret)
> -		goto err_disable_msi;
> +		goto err_disable_device;
>  
>  	return ret;
>  
> -err_disable_msi:
> -	pci_disable_msi(pdev);
>  err_disable_device:
>  	pci_disable_device(pdev);
>  err_put_node:

...