[PATCH] ata: Kconfig: Update SATA_MOBILE_LPM_POLICY default to med_power_with_dipm

[Niklas Cassel <cassel@kernel.org>]

From: Mario Limonciello <mario.limonciello@amd.com>

Historically this was set to "keep_firmware_settings" to prevent problems
with power management on very old drives. However it's been observed that
almost all modern Linux distributions either set the policy to
"med_power_with_dipm" in the kernel configuration or update it to this via
userspace policy changes. Update the policy default in the kernel to
"med_power_with_dipm" to match that behavior as well.

Changing the default was previously not a good idea, because LPM disables
detection of hot plug removals, however, since commit ae1f3db006b7 ("ata:
ahci: do not enable LPM on external ports"), a port marked as external
will always be initialized to "keep_firmware_settings", regardless of the
SATA_MOBILE_LPM_POLICY Kconfig value. Therefore, changing the default is
now considered safe (external ports included).

Signed-off-by: Mario Limonciello <mario.limonciello@amd.com>
[cassel: rebased and reworded commit message]
Signed-off-by: Niklas Cassel <cassel@kernel.org>
---
 drivers/ata/Kconfig | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/ata/Kconfig b/drivers/ata/Kconfig
index b595494ab9b4..e00536b49552 100644
--- a/drivers/ata/Kconfig
+++ b/drivers/ata/Kconfig
@@ -118,7 +118,7 @@ config SATA_AHCI
 config SATA_MOBILE_LPM_POLICY
 	int "Default SATA Link Power Management policy"
 	range 0 4
-	default 0
+	default 3
 	depends on SATA_AHCI
 	help
 	  Select the Default SATA Link Power Management (LPM) policy to use
-- 
2.44.0