[PATCH] usb: chipidea: udc: enable suspend interrupt after usb reset

[Xu Yang <xu.yang_2@nxp.com>]

Currently, suspend interrupt is enabled before pullup enable operation.
This will cause a suspend interrupt assert right after pullup DP. This
suspend interrupt is meaningless, so this will ignore such interrupt
by enable it after usb reset completed.

Signed-off-by: Xu Yang <xu.yang_2@nxp.com>
---
 drivers/usb/chipidea/udc.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/usb/chipidea/udc.c b/drivers/usb/chipidea/udc.c
index 2d7f616270c1..69ef3cd8d4f8 100644
--- a/drivers/usb/chipidea/udc.c
+++ b/drivers/usb/chipidea/udc.c
@@ -86,7 +86,7 @@ static int hw_device_state(struct ci_hdrc *ci, u32 dma)
 		hw_write(ci, OP_ENDPTLISTADDR, ~0, dma);
 		/* interrupt, error, port change, reset, sleep/suspend */
 		hw_write(ci, OP_USBINTR, ~0,
-			     USBi_UI|USBi_UEI|USBi_PCI|USBi_URI|USBi_SLI);
+			     USBi_UI|USBi_UEI|USBi_PCI|USBi_URI);
 	} else {
 		hw_write(ci, OP_USBINTR, ~0, 0);
 	}
@@ -877,6 +877,7 @@ __releases(ci->lock)
 __acquires(ci->lock)
 {
 	int retval;
+	u32 intr;
 
 	spin_unlock(&ci->lock);
 	if (ci->gadget.speed != USB_SPEED_UNKNOWN)
@@ -890,6 +891,11 @@ __acquires(ci->lock)
 	if (retval)
 		goto done;
 
+	/* clear SLI */
+	hw_write(ci, OP_USBSTS, USBi_SLI, USBi_SLI);
+	intr = hw_read(ci, OP_USBINTR, ~0);
+	hw_write(ci, OP_USBINTR, ~0, intr | USBi_SLI);
+
 	ci->status = usb_ep_alloc_request(&ci->ep0in->ep, GFP_ATOMIC);
 	if (ci->status == NULL)
 		retval = -ENOMEM;
-- 
2.34.1