[PATCH net-next v2] Documentation: networking: Add missing PHY_GET command in the message list

[Kory Maincent <kory.maincent@bootlin.com>]

ETHTOOL_MSG_PHY_GET/GET_REPLY/NTF is missing in the ethtool message list.
Add it to the ethool netlink documentation.

Signed-off-by: Kory Maincent <kory.maincent@bootlin.com>
---

Change in v2:
- Change PHY_NTF documentation
---
 Documentation/networking/ethtool-netlink.rst | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/Documentation/networking/ethtool-netlink.rst b/Documentation/networking/ethtool-netlink.rst
index 295563e91082..b25926071ece 100644
--- a/Documentation/networking/ethtool-netlink.rst
+++ b/Documentation/networking/ethtool-netlink.rst
@@ -236,6 +236,7 @@ Userspace to kernel:
   ``ETHTOOL_MSG_MM_GET``                get MAC merge layer state
   ``ETHTOOL_MSG_MM_SET``                set MAC merge layer parameters
   ``ETHTOOL_MSG_MODULE_FW_FLASH_ACT``   flash transceiver module firmware
+  ``ETHTOOL_MSG_PHY_GET``               get Ethernet PHY information
   ===================================== =================================
 
 Kernel to userspace:
@@ -283,6 +284,8 @@ Kernel to userspace:
   ``ETHTOOL_MSG_PLCA_NTF``                 PLCA RS parameters
   ``ETHTOOL_MSG_MM_GET_REPLY``             MAC merge layer status
   ``ETHTOOL_MSG_MODULE_FW_FLASH_NTF``      transceiver module flash updates
+  ``ETHTOOL_MSG_PHY_GET_REPLY``            Ethernet PHY information
+  ``ETHTOOL_MSG_PHY_NTF``                  Ethernet PHY information change
   ======================================== =================================
 
 ``GET`` requests are sent by userspace applications to retrieve device
-- 
2.34.1