[PATCH v1] configs: microchip_mpfs_icicle: disable DEBUG_UART

[Conor Dooley <conor@kernel.org>]

From: Conor Dooley <conor.dooley@microchip.com>

By default DEBUG_UART uses the SBI DBCN extension on S-Mode RISC-V
platforms, but the Icicle Kit's firmware doesn't support it. Since
DEBUG_UART is getting turned on automagically and this is somewhat
misleading, disable it in the Icicle kit's defconfig.

Signed-off-by: Conor Dooley <conor.dooley@microchip.com>
---
CC: Conor Dooley <conor.dooley@microchip.com>
CC: Cyril Jean <cyril.jean@microchip.com>
CC: Tom Rini <trini@konsulko.com>
CC: Leo Yu-Chi Liang <ycliang@andestech.com>
CC: u-boot@lists.denx.de
---
 configs/microchip_mpfs_icicle_defconfig | 1 +
 1 file changed, 1 insertion(+)

diff --git a/configs/microchip_mpfs_icicle_defconfig b/configs/microchip_mpfs_icicle_defconfig
index bb110225488..6937aa224a1 100644
--- a/configs/microchip_mpfs_icicle_defconfig
+++ b/configs/microchip_mpfs_icicle_defconfig
@@ -7,6 +7,7 @@ CONFIG_ENV_SIZE=0x2000
 CONFIG_DEFAULT_DEVICE_TREE="microchip/mpfs-icicle-kit"
 CONFIG_SYS_LOAD_ADDR=0x80200000
 CONFIG_SYS_MEM_TOP_HIDE=0x400000
+# CONFIG_DEBUG_UART is not set
 CONFIG_TARGET_MICROCHIP_ICICLE=y
 CONFIG_ARCH_RV64I=y
 CONFIG_RISCV_SMODE=y
-- 
2.45.2