[PATCH 5/5] clk: keystone: don't cache clock rate

[<a-christidis@ti.com>]

From: Michael Walle <mwalle@kernel.org>

The TISCI firmware will return 0 if the clock or consumer is not
enabled although there is a stored value in the firmware. IOW a call to
set rate will work but at get rate will always return 0 if the clock is
disabled.
The clk framework will try to cache the clock rate when it's requested
by a consumer. If the clock or consumer is not enabled at that point,
the cached value is 0, which is wrong. Thus, disable the cache
altogether.

Signed-off-by: Michael Walle <mwalle@kernel.org>
Reviewed-by: Kevin Hilman <khilman@baylibre.com>
Reviewed-by: Randolph Sapp <rs@ti.com>
Reviewed-by: Nishanth Menon <nm@ti.com>
Signed-off-by: Antonios Christidis <a-christidis@ti.com>
---
 drivers/clk/keystone/sci-clk.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/clk/keystone/sci-clk.c b/drivers/clk/keystone/sci-clk.c
index 9d5071223f4c..0a1565fdbb3b 100644
--- a/drivers/clk/keystone/sci-clk.c
+++ b/drivers/clk/keystone/sci-clk.c
@@ -333,6 +333,14 @@ static int _sci_clk_build(struct sci_clk_provider *provider,
 
 	init.ops = &sci_clk_ops;
 	init.num_parents = sci_clk->num_parents;
+
+	/*
+	 * A clock rate query to the SCI firmware will return 0 if either the
+	 * clock itself is disabled or the attached device/consumer is disabled.
+	 * This makes it inherently unsuitable for the caching of the clk
+	 * framework.
+	 */
+	init.flags = CLK_GET_RATE_NOCACHE;
 	sci_clk->hw.init = &init;
 
 	ret = devm_clk_hw_register(provider->dev, &sci_clk->hw);

-- 
2.34.1