[PATCH 3/5] platform/x86: hp-wmi: use mod_delayed_work to reset keep-alive timer

[Emre Cecanpunar <emreleno@gmail.com>]

The keep-alive mechanism re-applies fan settings every 90 seconds to
prevent the firmware from reverting to automatic mode after its 120 s
timeout. Fan settings are also applied immediately when the user writes
to the hwmon sysfs interface.

schedule_delayed_work() is a no-op when the work item is already
pending. If the user updates fan settings at T=85s, the keep-alive
still fires at T=90s (5 s after the update) instead of 90 s later.
This shortens the effective keep-alive window and may allow the
firmware timeout to expire between cycles.

Replace schedule_delayed_work() with mod_delayed_work() in both the
PWM_MODE_MAX and PWM_MODE_MANUAL cases. mod_delayed_work() resets the
delay to KEEP_ALIVE_DELAY_SECS from the time of each call, whether or
not the work is already pending, ensuring each user action and each
keep-alive expiry restarts the full 90 s window.

Signed-off-by: Emre Cecanpunar <emreleno@gmail.com>
---
 drivers/platform/x86/hp/hp-wmi.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/platform/x86/hp/hp-wmi.c b/drivers/platform/x86/hp/hp-wmi.c
index 41769c0861e5..a29f34588055 100644
--- a/drivers/platform/x86/hp/hp-wmi.c
+++ b/drivers/platform/x86/hp/hp-wmi.c
@@ -2342,8 +2342,8 @@ static int hp_wmi_apply_fan_settings(struct hp_wmi_hwmon_priv *priv)
 		ret = hp_wmi_fan_speed_max_set(1);
 		if (ret < 0)
 			return ret;
-		schedule_delayed_work(&priv->keep_alive_dwork,
-				      secs_to_jiffies(KEEP_ALIVE_DELAY_SECS));
+		mod_delayed_work(system_wq, &priv->keep_alive_dwork,
+				 secs_to_jiffies(KEEP_ALIVE_DELAY_SECS));
 		return 0;
 	case PWM_MODE_MANUAL:
 		if (!is_victus_s_thermal_profile())
@@ -2351,8 +2351,8 @@ static int hp_wmi_apply_fan_settings(struct hp_wmi_hwmon_priv *priv)
 		ret = hp_wmi_fan_speed_set(priv, pwm_to_rpm(priv->pwm, priv));
 		if (ret < 0)
 			return ret;
-		schedule_delayed_work(&priv->keep_alive_dwork,
-				      secs_to_jiffies(KEEP_ALIVE_DELAY_SECS));
+		mod_delayed_work(system_wq, &priv->keep_alive_dwork,
+				 secs_to_jiffies(KEEP_ALIVE_DELAY_SECS));
 		return 0;
 	case PWM_MODE_AUTO:
 		if (is_victus_s_thermal_profile()) {
-- 
2.53.0