[PATCH v6 2/2] i2c: qcom-geni: Add dynamic transfer timeout based on transfer length and frequency

[Aniket Randive <aniket.randive@oss.qualcomm.com>]

The driver uses a static XFER_TIMEOUT of HZ (1 second) for all transfers
regardless of message length or bus frequency, causing unnecessary
delays on error paths.

Use i2c_update_timeout() from i2c-core to compute the timeout dynamically
from the maximum message length across the transfer batch and the bus
frequency, then read adap->timeout at each wait site.  The timeout is
updated once per transfer batch in geni_i2c_xfer() so all internal paths
(FIFO rx/tx and both GPI modes) use a consistent value.

A 10x safety margin over the theoretical wire time is applied, with a
300ms floor to account for I2C clock stretching and other situations where
a slave may keep SCL asserted for an extended period, including faulty
devices holding the bus.  Both constants remain private to this driver.

Signed-off-by: Aniket Randive <aniket.randive@oss.qualcomm.com>
---
 drivers/i2c/busses/i2c-qcom-geni.c | 37 +++++++++++++++++++++++++++++--------
 1 file changed, 29 insertions(+), 8 deletions(-)

diff --git a/drivers/i2c/busses/i2c-qcom-geni.c b/drivers/i2c/busses/i2c-qcom-geni.c
index 96dbf04138be..d6fab3aa8468 100644
--- a/drivers/i2c/busses/i2c-qcom-geni.c
+++ b/drivers/i2c/busses/i2c-qcom-geni.c
@@ -74,9 +74,14 @@ enum geni_i2c_err_code {
 #define PACKING_BYTES_PW	4
 
 #define ABORT_TIMEOUT		HZ
-#define XFER_TIMEOUT		HZ
 #define RST_TIMEOUT		HZ
 
+/* 9 bits per byte (8 data + 1 ACK), 10x safety margin */
+#define I2C_TIMEOUT_SAFETY_COEFFICIENT	10
+
+/* 300ms floor: budget for clock stretching; slave may hold SCL low indefinitely */
+#define I2C_TIMEOUT_MIN_USEC		300000
+
 struct geni_i2c_desc {
 	bool no_dma_support;
 	unsigned int tx_fifo_depth;
@@ -471,7 +476,9 @@ static int geni_i2c_rx_one_msg(struct geni_i2c_dev *gi2c, struct i2c_msg *msg,
 	}
 
 	cur = gi2c->cur;
-	time_left = wait_for_completion_timeout(&gi2c->done, XFER_TIMEOUT);
+	i2c_update_timeout(&gi2c->adap, gi2c->clk_freq_out, len,
+			   I2C_TIMEOUT_SAFETY_COEFFICIENT, I2C_TIMEOUT_MIN_USEC);
+	time_left = wait_for_completion_timeout(&gi2c->done, gi2c->adap.timeout);
 	if (!time_left)
 		geni_i2c_abort_xfer(gi2c);
 
@@ -513,7 +520,9 @@ static int geni_i2c_tx_one_msg(struct geni_i2c_dev *gi2c, struct i2c_msg *msg,
 		writel_relaxed(1, se->base + SE_GENI_TX_WATERMARK_REG);
 
 	cur = gi2c->cur;
-	time_left = wait_for_completion_timeout(&gi2c->done, XFER_TIMEOUT);
+	i2c_update_timeout(&gi2c->adap, gi2c->clk_freq_out, len,
+			   I2C_TIMEOUT_SAFETY_COEFFICIENT, I2C_TIMEOUT_MIN_USEC);
+	time_left = wait_for_completion_timeout(&gi2c->done, gi2c->adap.timeout);
 	if (!time_left)
 		geni_i2c_abort_xfer(gi2c);
 
@@ -591,7 +600,7 @@ static void geni_i2c_gpi_multi_desc_unmap(struct geni_i2c_dev *gi2c, struct i2c_
  * geni_i2c_gpi_multi_xfer_timeout_handler() - Handles multi message transfer timeout
  * @dev: Pointer to the corresponding dev node
  * @multi_xfer: Pointer to the geni_i2c_gpi_multi_desc_xfer
- * @transfer_timeout_msecs: Timeout value in milliseconds
+ * @transfer_timeout_msecs: Per-message completion timeout in jiffies
  * @transfer_comp: Completion object of the transfer
  *
  * This function waits for the completion of each processed transfer messages
@@ -601,7 +610,7 @@ static void geni_i2c_gpi_multi_desc_unmap(struct geni_i2c_dev *gi2c, struct i2c_
  */
 static int geni_i2c_gpi_multi_xfer_timeout_handler(struct device *dev,
 						   struct geni_i2c_gpi_multi_desc_xfer *multi_xfer,
-						   u32 transfer_timeout_msecs,
+						   unsigned long timeout_jiffies,
 						   struct completion *transfer_comp)
 {
 	int i;
@@ -612,7 +621,7 @@ static int geni_i2c_gpi_multi_xfer_timeout_handler(struct device *dev,
 
 		if (multi_xfer->msg_idx_cnt != multi_xfer->irq_cnt) {
 			time_left = wait_for_completion_timeout(transfer_comp,
-								transfer_timeout_msecs);
+								timeout_jiffies);
 			if (!time_left) {
 				dev_err(dev, "%s: Transfer timeout\n", __func__);
 				return -ETIMEDOUT;
@@ -736,8 +745,17 @@ static int geni_i2c_gpi(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[],
 		dma_async_issue_pending(gi2c->tx_c);
 
 		if ((msg_idx == (gi2c->num_msgs - 1)) || flags & DMA_PREP_INTERRUPT) {
+			size_t max_len = 0;
+			int j;
+
+			for (j = 0; j < gi2c->num_msgs; j++)
+				max_len = max_t(size_t, max_len, msgs[j].len);
+			i2c_update_timeout(&gi2c->adap, gi2c->clk_freq_out, max_len,
+					   I2C_TIMEOUT_SAFETY_COEFFICIENT,
+					   I2C_TIMEOUT_MIN_USEC);
 			ret = geni_i2c_gpi_multi_xfer_timeout_handler(gi2c->se.dev, gi2c_gpi_xfer,
-								      XFER_TIMEOUT, &gi2c->done);
+								      gi2c->adap.timeout,
+								      &gi2c->done);
 			if (ret) {
 				dev_err(gi2c->se.dev,
 					"I2C multi write msg transfer timeout: %d\n",
@@ -852,7 +870,10 @@ static int geni_i2c_gpi_xfer(struct geni_i2c_dev *gi2c, struct i2c_msg msgs[], i
 
 		if (!gi2c->is_tx_multi_desc_xfer) {
 			dma_async_issue_pending(gi2c->tx_c);
-			time_left = wait_for_completion_timeout(&gi2c->done, XFER_TIMEOUT);
+			i2c_update_timeout(&gi2c->adap, gi2c->clk_freq_out, msgs[i].len,
+					   I2C_TIMEOUT_SAFETY_COEFFICIENT,
+					   I2C_TIMEOUT_MIN_USEC);
+			time_left = wait_for_completion_timeout(&gi2c->done, gi2c->adap.timeout);
 			if (!time_left) {
 				dev_err(gi2c->se.dev, "%s:I2C timeout\n", __func__);
 				gi2c->err = -ETIMEDOUT;

-- 
2.34.1