From: Alex Williamson <alex@shazbot.org>
To: Josh Hilke <jrhilke@google.com>
Cc: David Matlack <dmatlack@google.com>,
Shuah Khan <shuah@kernel.org>,
linux-kernel@vger.kernel.org, kvm@vger.kernel.org,
linux-kselftest@vger.kernel.org,
Vipin Sharma <vipinsh@google.com>,
Alex Williamson <alex.williamson@nvidia.com>,
alex@shazbot.org
Subject: Re: [PATCH v10 0/3] vfio: selftests: Add driver for Intel Ethernet Gigabit Controller (IGB)
Date: Wed, 5 Aug 2026 09:46:21 -0600 [thread overview]
Message-ID: <20260805094621.665d5ec0@shazbot.org> (raw)
In-Reply-To: <20260805-igb_v3_b4-v10-0-9c86dc849c0d@google.com>
On Wed, 05 Aug 2026 00:20:57 +0000
Josh Hilke <jrhilke@google.com> wrote:
> This v10 of a series which adds a VFIO selftest driver for the Intel
> Gigabit Ethernet controller (IGB), specifically targeting the 82576
> device. IGB is fully virtualized in QEMU, making it suitable for running
> VFIO selftests without specialized hardware.
LGTM, passes on physical NIC. Thanks for the re-spins.
David, do you want to double check and provide an Ack? Thanks,
Alex
> v9: https://lore.kernel.org/kvm/20260730-igb_v3_b4-v9-0-9e4d8682437e@google.com/
>
> Version 10 adds an assert in the IGB driver to prevent DMA transfers
> smaller than 60 bytes, avoiding out-of-bounds DMA writes caused by
> hardware padding on short transfers, and squashes the recovery logic
> (previously Patch 5) into the main driver patch to keep the driver
> self-contained. Also add some logic from Alex to correct the ordering of
> Tx/Rx queue setup.
>
> This series applies on top of linux-next, but the VFIO selftests don't
> build without this patch which fixes a compile error for the test
> fixture:
> https://lore.kernel.org/linux-kselftest/20260630213341.1664345-1-dmatlack@google.com/
>
> Testing
> =======
> - VFIO selftests builds clean at every commit
> - vfio_pci_driver_test passes using IGB driver + QEMU. Use the following
> command to run the tests:
>
> vng \
> --run arch/x86/boot/bzImage \
> --user root \
> --disable-microvm \
> --memory 32G \
> --cpus 8 \
> --qemu-opts="-M q35,accel=kvm,kernel-irqchip=split" \
> --qemu-opts="-device intel-iommu,intremap=on,caching-mode=on,device-iotlb=on" \
> --qemu-opts="-netdev user,id=net0 -device igb,netdev=net0,addr=09.0" \
> --append "console=ttyS0 earlyprintk=ttyS0 intel_iommu=on iommu=pt" \
> --exec "modprobe vfio-pci && \
> ./tools/testing/selftests/vfio/scripts/setup.sh 0000:00:09.0 && \
> ./tools/testing/selftests/vfio/scripts/run.sh ./tools/testing/selftests/vfio/vfio_pci_driver_test"
> --------
> Changelog:
>
> v9 -> v10:
> - Add assert in IGB driver to prevent DMA transfers < 60 bytes (Ethernet
> minimum payload size) to avoid memory corruption from hardware padding. (Sashiko)
> - Squash recovery logic into the main driver patch to make the driver self-contained.
> - Set per-queue enable bits _after_ enabling global queue bits (Alex)
>
> v8 -> v9:
> - Enable Pad Short Packets (PSP) in TCTL to support transfers < 60 bytes. (Sashiko)
> - Correct misleading comment about interrupt delivery in Patch 1. (Sashiko)
>
> v7 -> v8:
> - Rebase onto linux-next branch. (Alex)
> - Implement retry limit in vfio_pci_device_reset(). (Alex)
> - Carry David's reviewed-by tag onto the patches that haven't been
> touched since v6.
>
> v6 -> v7:
> - Allow the driver to be used on any architecture. (Alex)
> - Fix regression in reset logic for the physical device. (Alex)
>
> v5 -> v6:
> - Retry on EAGAIN during device reset to handle transient lock contention (Sashiko).
>
> v4 -> v5:
> - Reordered igb_remove() to reset the device before disabling MSI-X (Sashiko)
> - Refactored hardware reset logic into igb_reset() helper.
> - Simplified reset completion check to usleep + assertion instead of retry loop (Sashiko).
> - Allow arbitrary test data by enabling Multicast Promiscuous (MPE)
> and Broadcast Accept (BAM) modes (Sashiko).
> - Fixed igb_send_msi() to use MSIX_VECTOR_MASK instead of magic number (Sashiko).
>
> v3 -> v4
> - Enable MSI-X mode in GPIE (Sashiko)
> - Fix hardware initilization order to avoid race conditions (Alex/Sashiko)
> - Add memory barrier to prevent speculative reads (Alex/Sashiko)
> - Clean up stale references in commit messages and comments (Alex/Sashiko)
> - Add a comment to address software/firmware semaphore (Alex/Sashiko)
>
> v2 -> v3
> - Poll reset bit and document the required wait time (David/Sashiko)
> - Fix the logic for enabling PCI_COMMAND_MEMORY (David/Sashiko)
> - Fail the test if autonegotation fails (David/Sashiko)
> - Handle endianness conversions (David/Sashiko)
> - Use real IGB headers at the start of the series (David)
> - Add E1000_TXD_CMD_IFCS to the TX descriptor command word (Sashiko)
>
> v1 -> v2
> - Removed the chunking loop in igb_memcpy_start() (David)
> - Removed redundant writes to status_error and hdr_addr (David)
> - Include official IGB header files (David)
>
> Signed-off-by: Josh Hilke <jrhilke@google.com>
> ---
> Alex Williamson (1):
> vfio: selftests: Add helpers to re-enable interrupts
>
> Josh Hilke (2):
> vfio: selftests: igb: Add driver for Intel 82576 device
> vfio: selftests: Retry on EAGAIN during device reset
>
> .../selftests/vfio/lib/drivers/igb/e1000_82575.h | 1 +
> .../selftests/vfio/lib/drivers/igb/e1000_defines.h | 1 +
> .../selftests/vfio/lib/drivers/igb/e1000_regs.h | 1 +
> tools/testing/selftests/vfio/lib/drivers/igb/igb.c | 585 +++++++++++++++++++++
> .../vfio/lib/include/libvfio/vfio_pci_device.h | 15 +
> tools/testing/selftests/vfio/lib/libvfio.mk | 1 +
> tools/testing/selftests/vfio/lib/vfio_pci_device.c | 42 +-
> tools/testing/selftests/vfio/lib/vfio_pci_driver.c | 3 +-
> 8 files changed, 647 insertions(+), 2 deletions(-)
> ---
> base-commit: 0f6da28aab51b16762ed82e8fdeaa5042da45b08
> change-id: 20260707-igb_v3_b4-49194c14373c
>
> Best regards,
next prev parent reply other threads:[~2026-08-05 15:46 UTC|newest]
Thread overview: 6+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-08-05 0:20 [PATCH v10 0/3] vfio: selftests: Add driver for Intel Ethernet Gigabit Controller (IGB) Josh Hilke
2026-08-05 0:20 ` [PATCH v10 1/3] vfio: selftests: Add helpers to re-enable interrupts Josh Hilke
2026-08-05 0:20 ` [PATCH v10 2/3] vfio: selftests: igb: Add driver for Intel 82576 device Josh Hilke
2026-08-05 0:21 ` [PATCH v10 3/3] vfio: selftests: Retry on EAGAIN during device reset Josh Hilke
2026-08-05 15:46 ` Alex Williamson [this message]
2026-08-07 22:27 ` [PATCH v10 0/3] vfio: selftests: Add driver for Intel Ethernet Gigabit Controller (IGB) David Matlack
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20260805094621.665d5ec0@shazbot.org \
--to=alex@shazbot.org \
--cc=alex.williamson@nvidia.com \
--cc=dmatlack@google.com \
--cc=jrhilke@google.com \
--cc=kvm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-kselftest@vger.kernel.org \
--cc=shuah@kernel.org \
--cc=vipinsh@google.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.