[PATCH 3/3] i2c: brcmstb: Correct optional IRQ handling

[phucduc.bui@gmail.com]

From: bui duc phuc <phucduc.bui@gmail.com>

dev->irq is assigned from platform_get_irq_optional(), which returns a
non-zero interrupt number on success or a negative error number on
failure. Therefore, 0 is not a valid IRQ number.

Check for a positive IRQ number before requesting the IRQ instead of
treating 0 as a valid IRQ.

Also use a positive IRQ number when reporting the operating mode. The
driver sets dev->irq to -1 when devm_request_irq() fails, so the mode
check should only consider positive IRQ numbers as interrupt mode.

Signed-off-by: bui duc phuc <phucduc.bui@gmail.com>
---
 drivers/i2c/busses/i2c-brcmstb.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/i2c/busses/i2c-brcmstb.c b/drivers/i2c/busses/i2c-brcmstb.c
index 91525a36e575..3adc73f3d608 100644
--- a/drivers/i2c/busses/i2c-brcmstb.c
+++ b/drivers/i2c/busses/i2c-brcmstb.c
@@ -655,7 +655,7 @@ static int brcmstb_i2c_probe(struct platform_device *pdev)
 	brcmstb_i2c_enable_disable_irq(dev, INT_DISABLE);
 
 	/* register the ISR handler */
-	if (dev->irq >= 0) {
+	if (dev->irq > 0) {
 		rc = devm_request_irq(&pdev->dev, dev->irq, brcmstb_i2c_isr,
 				      IRQF_SHARED,
 				      int_name ? int_name : pdev->name,
@@ -697,7 +697,7 @@ static int brcmstb_i2c_probe(struct platform_device *pdev)
 
 	dev_info(dev->device, "%s@%dhz registered in %s mode\n",
 		 int_name ? int_name : " ", dev->clk_freq_hz,
-		 (dev->irq >= 0) ? "interrupt" : "polling");
+		 (dev->irq > 0) ? "interrupt" : "polling");
 
 	return 0;
 }
-- 
2.43.0