[PATCH net v2 1/5] net: phy: split phy_probe() error paths

[Xuanqiang Luo <xuanqiang.luo@linux.dev>]

From: Xuanqiang Luo <luoxuanqiang@kylinos.cn>

phy_probe() uses one cleanup path for failures at every initialization
stage. This runs cleanup for resources that have not been initialized.

Split the cleanup by initialization stage so each failure path unwinds
only the resources that may have been initialized.

Signed-off-by: Xuanqiang Luo <luoxuanqiang@kylinos.cn>
---
 drivers/net/phy/phy_device.c | 20 +++++++++++---------
 1 file changed, 11 insertions(+), 9 deletions(-)

diff --git a/drivers/net/phy/phy_device.c b/drivers/net/phy/phy_device.c
index 0615228459ef4..c9976ffa7128c 100644
--- a/drivers/net/phy/phy_device.c
+++ b/drivers/net/phy/phy_device.c
@@ -3681,7 +3681,7 @@ static int phy_probe(struct device *dev)
 	if (phydev->drv->probe) {
 		err = phydev->drv->probe(phydev);
 		if (err)
-			goto out;
+			goto out_reset;
 	}
 
 	phy_disable_interrupts(phydev);
@@ -3702,7 +3702,7 @@ static int phy_probe(struct device *dev)
 		err = genphy_read_abilities(phydev);
 
 	if (err)
-		goto out;
+		goto out_reset;
 
 	if (!linkmode_test_bit(ETHTOOL_LINK_MODE_Autoneg_BIT,
 			       phydev->supported))
@@ -3719,7 +3719,7 @@ static int phy_probe(struct device *dev)
 
 	err = phy_setup_ports(phydev);
 	if (err)
-		goto out;
+		goto out_ports;
 
 	phy_advertise_supported(phydev);
 
@@ -3728,7 +3728,7 @@ static int phy_probe(struct device *dev)
 	 */
 	err = genphy_c45_read_eee_adv(phydev, phydev->advertising_eee);
 	if (err)
-		goto out;
+		goto out_ports;
 
 	/* Get the EEE modes we want to prohibit. */
 	of_set_phy_eee_broken(phydev);
@@ -3781,20 +3781,22 @@ static int phy_probe(struct device *dev)
 	if (IS_ENABLED(CONFIG_PHYLIB_LEDS) && !phy_driver_is_genphy(phydev)) {
 		err = of_phy_leds(phydev);
 		if (err)
-			goto out;
+			goto out_led_triggers;
 	}
 
 	return 0;
 
-out:
+out_led_triggers:
+	if (!phydev->is_on_sfp_module)
+		phy_led_triggers_unregister(phydev);
+
+out_ports:
 	sfp_bus_del_upstream(phydev->sfp_bus);
 	phydev->sfp_bus = NULL;
 
 	phy_cleanup_ports(phydev);
 
-	if (!phydev->is_on_sfp_module)
-		phy_led_triggers_unregister(phydev);
-
+out_reset:
 	/* Re-assert the reset signal on error */
 	phy_device_reset(phydev, 1);
 
-- 
2.43.0