[PATCH net v4 3/6] net: phy: set PHY_READY after LED setup

[Xuanqiang Luo <xuanqiang.luo@linux.dev>]

From: Xuanqiang Luo <luoxuanqiang@kylinos.cn>

phy_probe() sets PHY_READY before calling of_phy_leds(). If LED setup
fails, the error path releases the initialized resources while the PHY
state remains READY even though probing failed.

Set PHY_READY only after LED setup succeeds.

Fixes: 01e5b728e9e4 ("net: phy: Add a binding for PHY LEDs")
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Xuanqiang Luo <luoxuanqiang@kylinos.cn>
---
 drivers/net/phy/phy_device.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/net/phy/phy_device.c b/drivers/net/phy/phy_device.c
index 4b9b2300422fb..891df46d0597f 100644
--- a/drivers/net/phy/phy_device.c
+++ b/drivers/net/phy/phy_device.c
@@ -3824,9 +3824,6 @@ static int phy_probe(struct device *dev)
 				 phydev->supported);
 	}
 
-	/* Set the state to READY by default */
-	phydev->state = PHY_READY;
-
 	/* Register the PHY LED triggers */
 	if (!phydev->is_on_sfp_module)
 		phy_led_triggers_register(phydev);
@@ -3840,6 +3837,9 @@ static int phy_probe(struct device *dev)
 			goto out_unreg_led_triggers;
 	}
 
+	/* Set the state to READY by default */
+	phydev->state = PHY_READY;
+
 	return 0;
 
 out_unreg_led_triggers:
-- 
2.43.0