[PATCH] hwmon: (gpio-fan) fix pm_runtime imbalance for alarm-only fans

[Cong Nguyen <congnt264@gmail.com>]

pm_runtime_enable() runs unconditionally at the end of probe, but the
devm action that calls pm_runtime_disable() is registered only when
control GPIOs are present. An alarm-only fan (no control GPIOs, alarm
GPIO optional) is a valid DT configuration; on unbind the runtime PM
core warns about the missing disable.

Use devm_pm_runtime_enable() so disable is automatic on device release,
and drop the redundant pm_runtime_disable() from gpio_fan_stop().

Fixes: 0d01110e6356 ("hwmon: (gpio-fan) Add regulator support")
Cc: stable@vger.kernel.org
Assisted-by: Claude:claude-opus-4
Signed-off-by: Cong Nguyen <congnt264@gmail.com>
---
 drivers/hwmon/gpio-fan.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/hwmon/gpio-fan.c b/drivers/hwmon/gpio-fan.c
index 084828e1e281..0bd5561b7a40 100644
--- a/drivers/hwmon/gpio-fan.c
+++ b/drivers/hwmon/gpio-fan.c
@@ -524,8 +524,6 @@ static void gpio_fan_stop(void *data)
 	mutex_lock(&fan_data->lock);
 	set_fan_speed(data, 0);
 	mutex_unlock(&fan_data->lock);
-
-	pm_runtime_disable(fan_data->dev);
 }
 
 static int gpio_fan_probe(struct platform_device *pdev)
@@ -581,7 +579,9 @@ static int gpio_fan_probe(struct platform_device *pdev)
 	}
 
 	pm_runtime_set_suspended(&pdev->dev);
-	pm_runtime_enable(&pdev->dev);
+	err = devm_pm_runtime_enable(&pdev->dev);
+	if (err)
+		return err;
 	/* If current GPIO state is active, mark RPM as active as well */
 	if (fan_data->speed_index > 0) {
 		int ret;
-- 
2.25.1