[PATCH] mmc: sdhci-pxav3: disable clock inversion for SD HS cards

[Rosen Penev <rosenp@gmail.com>]

The SDIO3 Configuration register branch of pxav3_set_uhs_signaling()
only clears the clock-inversion and feedback-clock bits for
MMC_TIMING_MMC_HS.  As a result, MMC_TIMING_SD_HS (ordinary SD High
Speed) falls through to the default case, which sets SDIO3_CONF_CLK_INV
and leaves the feedback clock cleared.

According to erratum FE-2946959, clock inversion is only needed for
slow frequencies when the card hold-time requirement is high and is not
required nor desirable for high-speed modes.  SD High Speed runs at 50
MHz, so the same timing argument that applies to MMC High Speed holds.
Treat MMC_TIMING_SD_HS the same as MMC_TIMING_MMC_HS and clear the
clock-inversion and feedback-clock bits for both.

Assisted-by: opencode:big-pickle
Signed-off-by: Rosen Penev <rosenp@gmail.com>
---
 drivers/mmc/host/sdhci-pxav3.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/host/sdhci-pxav3.c b/drivers/mmc/host/sdhci-pxav3.c
index db9dfa92cb57..9e6703e005e2 100644
--- a/drivers/mmc/host/sdhci-pxav3.c
+++ b/drivers/mmc/host/sdhci-pxav3.c
@@ -284,7 +284,8 @@ static void pxav3_set_uhs_signaling(struct sdhci_host *host, unsigned int uhs)
 		    uhs == MMC_TIMING_UHS_DDR50) {
 			reg_val &= ~SDIO3_CONF_CLK_INV;
 			reg_val |= SDIO3_CONF_SD_FB_CLK;
-		} else if (uhs == MMC_TIMING_MMC_HS) {
+		} else if (uhs == MMC_TIMING_MMC_HS ||
+			   uhs == MMC_TIMING_SD_HS) {
 			reg_val &= ~SDIO3_CONF_CLK_INV;
 			reg_val &= ~SDIO3_CONF_SD_FB_CLK;
 		} else {
-- 
2.55.0