From: <gregkh@linuxfoundation.org>
To: kmehltretter@gmail.com,Frank.Li@nxp.com,gregkh@linuxfoundation.org,sashiko-bot@kernel.org
Cc: <stable@vger.kernel.org>
Subject: FAILED: patch "[PATCH] serial: imx: serialize imx_uart_ports[] lifetime" failed to apply to 5.15-stable tree
Date: Thu, 03 Sep 2026 14:38:33 +0200 [thread overview]
Message-ID: <2026090333-scared-direness-4881@gregkh> (raw)
The patch below does not apply to the 5.15-stable tree.
If someone wants it applied there, or to any other stable or longterm
tree, then please email the backport, including the original git commit
id to <stable@vger.kernel.org>.
To reproduce the conflict and resubmit, you may use the following commands:
git fetch https://git.kernel.org/pub/scm/linux/kernel/git/stable/linux.git/ linux-5.15.y
git checkout FETCH_HEAD
git cherry-pick -x 8b0b29fdcb47907ae0296b8fe829e918e05e300f
# <resolve conflicts, build, test, etc.>
git commit -s
git send-email --to '<stable@vger.kernel.org>' --in-reply-to '2026090333-scared-direness-4881@gregkh' --subject-prefix 'PATCH 5.15.y' 'HEAD^..'
Possible dependencies:
thanks,
greg k-h
------------------ original commit in Linus's tree ------------------
From 8b0b29fdcb47907ae0296b8fe829e918e05e300f Mon Sep 17 00:00:00 2001
From: Karl Mehltretter <kmehltretter@gmail.com>
Date: Fri, 31 Jul 2026 20:18:44 +0200
Subject: [PATCH] serial: imx: serialize imx_uart_ports[] lifetime
imx_uart_probe() publishes its devm-allocated port in imx_uart_ports[]
before uart_add_one_port() because console setup uses the table. The entry
is not cleared when adding the port fails or after removal, leaving a
dangling pointer.
A sibling probe can register the shared console through that stale entry.
This was reproduced under KASAN on QEMU mcimx6ul-evk by unbinding a
sibling UART, unbinding the console UART and rebinding the sibling.
Keep the entry valid through uart_remove_one_port(), then clear it. Protect
port addition and removal together with their table updates so sibling
operations cannot interleave. Reject an occupied slot rather than
clobbering an active port during a duplicate-line probe.
Fixes: dbff4e9ea2e8 ("IMX UART: remove statically initialized tables")
Fixes: 9f322ad064f9 ("imx: serial: handle initialisation failure correctly")
Reported-by: Sashiko <sashiko-bot@kernel.org>
Link: https://lore.kernel.org/all/20260719162850.043B41F000E9@smtp.kernel.org
Link: https://lore.kernel.org/all/20260719222501.CB4CB1F000E9@smtp.kernel.org
Cc: stable@vger.kernel.org
Assisted-by: Claude:claude-fable-5
Signed-off-by: Karl Mehltretter <kmehltretter@gmail.com>
Reviewed-by: Frank Li <Frank.Li@nxp.com>
Link: https://patch.msgid.link/20260731181844.11330-6-kmehltretter@gmail.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c
index 95fdb60e06a7..513dbe95f7e9 100644
--- a/drivers/tty/serial/imx.c
+++ b/drivers/tty/serial/imx.c
@@ -22,6 +22,7 @@
#include <linux/clk.h>
#include <linux/delay.h>
#include <linux/ktime.h>
+#include <linux/mutex.h>
#include <linux/pinctrl/consumer.h>
#include <linux/rational.h>
#include <linux/slab.h>
@@ -2080,6 +2081,9 @@ static const struct uart_ops imx_uart_pops = {
static struct imx_port *imx_uart_ports[UART_NR];
+/* Held across uart_add/remove_one_port(); console callbacks must not take it. */
+static DEFINE_MUTEX(imx_uart_ports_lock);
+
#if IS_ENABLED(CONFIG_SERIAL_IMX_CONSOLE)
static void imx_uart_console_putchar(struct uart_port *port, unsigned char ch)
{
@@ -2621,11 +2625,19 @@ static int imx_uart_probe(struct platform_device *pdev)
goto err_clk;
}
- imx_uart_ports[sport->port.line] = sport;
-
platform_set_drvdata(pdev, sport);
- ret = uart_add_one_port(&imx_uart_uart_driver, &sport->port);
+ scoped_guard(mutex, &imx_uart_ports_lock) {
+ if (imx_uart_ports[sport->port.line]) {
+ ret = -EBUSY;
+ } else {
+ imx_uart_ports[sport->port.line] = sport;
+ ret = uart_add_one_port(&imx_uart_uart_driver,
+ &sport->port);
+ if (ret)
+ imx_uart_ports[sport->port.line] = NULL;
+ }
+ }
err_clk:
clk_disable_unprepare(sport->clk_ipg);
@@ -2637,7 +2649,9 @@ static void imx_uart_remove(struct platform_device *pdev)
{
struct imx_port *sport = platform_get_drvdata(pdev);
+ guard(mutex)(&imx_uart_ports_lock);
uart_remove_one_port(&imx_uart_uart_driver, &sport->port);
+ imx_uart_ports[sport->port.line] = NULL;
}
static void imx_uart_restore_context(struct imx_port *sport)
next reply other threads:[~2026-09-03 12:54 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-09-03 12:38 gregkh [this message]
2026-09-04 13:18 ` [PATCH 5.15.y 1/2] serial: imx: Convert to platform remove callback returning void Sasha Levin
2026-09-04 13:18 ` [PATCH 5.15.y 2/2] serial: imx: serialize imx_uart_ports[] lifetime Sasha Levin
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=2026090333-scared-direness-4881@gregkh \
--to=gregkh@linuxfoundation.org \
--cc=Frank.Li@nxp.com \
--cc=kmehltretter@gmail.com \
--cc=sashiko-bot@kernel.org \
--cc=stable@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.