[PATCH] spi: fix typos in comments

[Hemanth Selam <hemanth.selam@gmail.com>]

Fix typos in comments, reported by scripts/checkpatch.pl using the
misspelling list in scripts/spelling.txt.  Only touches comments, no code
changes.

Assisted-by: Cursor:claude-opus-5
Signed-off-by: Hemanth Selam <hemanth.selam@gmail.com>
---
 drivers/spi/spi-bcm63xx.c     | 2 +-
 drivers/spi/spi-imx.c         | 2 +-
 drivers/spi/spi-omap2-mcspi.c | 2 +-
 drivers/spi/spi-pic32.c       | 2 +-
 drivers/spi/spi-s3c64xx.c     | 2 +-
 drivers/spi/spi-stm32.c       | 2 +-
 drivers/spi/spi-sun6i.c       | 2 +-
 drivers/spi/spi-xilinx.c      | 2 +-
 8 files changed, 8 insertions(+), 8 deletions(-)

diff --git a/drivers/spi/spi-bcm63xx.c b/drivers/spi/spi-bcm63xx.c
index 1d8e257bad30..3f349c1db581 100644
--- a/drivers/spi/spi-bcm63xx.c
+++ b/drivers/spi/spi-bcm63xx.c
@@ -413,7 +413,7 @@ static irqreturn_t bcm63xx_spi_interrupt(int irq, void *dev_id)
 	struct bcm63xx_spi *bs = spi_controller_get_devdata(host);
 	u8 intr;
 
-	/* Read interupts and clear them immediately */
+	/* Read interrupts and clear them immediately */
 	intr = bcm_spi_readb(bs, SPI_INT_STATUS);
 	bcm_spi_writeb(bs, SPI_INTR_CLEAR_ALL, SPI_INT_STATUS);
 	bcm_spi_writeb(bs, 0, SPI_INT_MASK);
diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c
index 79a6c1a60b0a..6f9686df0486 100644
--- a/drivers/spi/spi-imx.c
+++ b/drivers/spi/spi-imx.c
@@ -673,7 +673,7 @@ static int mx51_ecspi_prepare_message(struct spi_imx_data *spi_imx,
 	 * propagate into the hardware. It takes exactly one tick of the
 	 * SCLK clock, but we will wait two SCLK clock just to be sure. The
 	 * effect of the delay it takes for the hardware to apply changes
-	 * is noticable if the SCLK clock run very slow. In such a case, if
+	 * is noticeable if the SCLK clock run very slow. In such a case, if
 	 * the polarity of SCLK should be inverted, the GPIO ChipSelect might
 	 * be asserted before the SCLK polarity changes, which would disrupt
 	 * the SPI communication as the device on the other end would consider
diff --git a/drivers/spi/spi-omap2-mcspi.c b/drivers/spi/spi-omap2-mcspi.c
index a3355147f5de..90f3990e0060 100644
--- a/drivers/spi/spi-omap2-mcspi.c
+++ b/drivers/spi/spi-omap2-mcspi.c
@@ -1244,7 +1244,7 @@ static int omap2_mcspi_transfer_one(struct spi_controller *ctlr,
 		omap2_mcspi_set_fifo(spi, t, 0);
 
 out:
-	/* Restore defaults if they were overriden */
+	/* Restore defaults if they were overridden */
 	if (par_override) {
 		par_override = 0;
 		status = omap2_mcspi_setup_transfer(spi, NULL);
diff --git a/drivers/spi/spi-pic32.c b/drivers/spi/spi-pic32.c
index 972128271e4b..8363bc873b03 100644
--- a/drivers/spi/spi-pic32.c
+++ b/drivers/spi/spi-pic32.c
@@ -53,7 +53,7 @@ struct pic32_spi_regs {
 #define  TX_FIFO_ALL_EMPTY	0 /* completely empty */
 #define  TX_FIFO_EMPTY		1 /* empty */
 #define  TX_FIFO_HALF_EMPTY	2 /* empty by half or more */
-#define  TX_FIFO_NOT_FULL	3 /* atleast one empty */
+#define  TX_FIFO_NOT_FULL	3 /* at least one empty */
 
 #define CTRL_MSTEN	BIT(5) /* enable master mode */
 #define CTRL_CKP	BIT(6) /* active low */
diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
index 8d4120cf9df1..3546414dfc70 100644
--- a/drivers/spi/spi-s3c64xx.c
+++ b/drivers/spi/spi-s3c64xx.c
@@ -661,7 +661,7 @@ static int s3c64xx_wait_for_pio(struct s3c64xx_spi_driver_data *sdd,
 	 * loops = length / max fifo size (calculated by using the
 	 * fifo mask).
 	 * For any size less than the fifo size the below code is
-	 * executed atleast once.
+	 * executed at least once.
 	 */
 	loops = xfer->len / sdd->fifo_depth;
 	buf = xfer->rx_buf;
diff --git a/drivers/spi/spi-stm32.c b/drivers/spi/spi-stm32.c
index be88e62075af..5f5c43ae5096 100644
--- a/drivers/spi/spi-stm32.c
+++ b/drivers/spi/spi-stm32.c
@@ -515,7 +515,7 @@ static int stm32h7_spi_get_bpw_mask(struct stm32_spi *spi)
 
 	/*
 	 * The most significant bit at DSIZE bit field is reserved when the
-	 * maximum data size of periperal instances is limited to 16-bit
+	 * maximum data size of peripheral instances is limited to 16-bit
 	 */
 	stm32_spi_set_bits(spi, STM32H7_SPI_CFG1, STM32H7_SPI_CFG1_DSIZE);
 
diff --git a/drivers/spi/spi-sun6i.c b/drivers/spi/spi-sun6i.c
index 4631e9c7ca1d..6b7a05dd0de8 100644
--- a/drivers/spi/spi-sun6i.c
+++ b/drivers/spi/spi-sun6i.c
@@ -386,7 +386,7 @@ static int sun6i_spi_transfer_one(struct spi_controller *host,
 		 * SPI_CLK = MOD_CLK / (2 ^ cdr)
 		 * Or we can use CDR2, which is calculated with the formula:
 		 * SPI_CLK = MOD_CLK / (2 * (cdr + 1))
-		 * Wether we use the former or the latter is set through the
+		 * Whether we use the former or the latter is set through the
 		 * DRS bit.
 		 *
 		 * First try CDR2, and if we can't reach the expected
diff --git a/drivers/spi/spi-xilinx.c b/drivers/spi/spi-xilinx.c
index dc1e968659e1..df4ea99a5427 100644
--- a/drivers/spi/spi-xilinx.c
+++ b/drivers/spi/spi-xilinx.c
@@ -460,7 +460,7 @@ static int xilinx_spi_probe(struct platform_device *pdev)
 	host->num_chipselect = num_cs;
 
 	/*
-	 * Detect endianess on the IP via loop bit in CR. Detection
+	 * Detect endianness on the IP via loop bit in CR. Detection
 	 * must be done before reset is sent because incorrect reset
 	 * value generates error interrupt.
 	 * Setup little endian helper functions first and try to use them
-- 
2.48.1