Re: [PATCHv2 net] net: phy: marvell: undo WoL setup when Wake-on-LAN is disabled

[Jakub Kicinski <kuba@kernel.org>]

On Mon, 14 Sep 2026 14:24:09 -0700 Rosen Penev wrote:
> Fully disabling Wake-on-LAN on the 88E1318S/88E1510 used to leave
> the WoL interrupt enable bit (CSIER.WOL_EIE) set and LED[2]
> configured as the INTn pin. A magic packet arriving after "wol d"
> would still assert INTn, and a later "wol g" re-enabled WoL from a
> dirty register state.
> 
> Fully disabling WoL clears CSIER.WOL_EIE on the copper page. The
> LED[2]/INTn pin mux is disposed of only when this driver forced it to
> the INTn function: the INTn enable and polarity bits read at arming
> time are saved, and restored once all WoL options are cleared, so PHYs
> serving the MAC interrupt, strap configs, or marvell,reg-init values
> are never touched. The FORCE_INT bit is not set while disposing of the
> pin: it holds the interrupt line asserted and turns the shared PHY
> interrupt into a "nobody cared" IRQ storm when the PHY interrupt is in
> use.

Oof, this is pretty hard to read. The paragraph is pretty much 2
run-on sentences.

Please add info about how the issue was discovered and how it was
tested. If you don't have HW back to net-next without Fixes it goes.
The AI is pretty bad at judging severity, I need to find time to tune
the Fixes suggestions further :/
-- 
pw-bot: cr