From: Jacob Keller <jacob.e.keller@intel.com>
To: Jacob Keller <jacob.e.keller@intel.com>,
Grzegorz Nitka <grzegorz.nitka@intel.com>,
Arkadiusz Kubalewski <arkadiusz.kubalewski@intel.com>,
Intel Wired LAN <intel-wired-lan@lists.osuosl.org>,
Maciej Machnikowski <maciej.machnikowski@intel.com>,
Przemyslaw Korba <przemyslaw.korba@intel.com>,
netdev@vger.kernel.org,
Anthony Nguyen <anthony.l.nguyen@intel.com>
Cc: Jacob Keller <jacob.e.keller@intel.com>
Subject: [PATCH iwl-net v2 04/15] ice: set in_use only after preparing Tx timestamp index
Date: Tue, 22 Sep 2026 11:02:37 -0700 [thread overview]
Message-ID: <20260922-jk-e825c-timestamp-processing-logic-fixes-srcu-v2-4-e55b692d0e6b@intel.com> (raw)
In-Reply-To: <20260922-jk-e825c-timestamp-processing-logic-fixes-srcu-v2-0-e55b692d0e6b@intel.com>
The ice_ptp_request_ts() function is used to request a timestamp index for
use with a packet. When reserving an index, it sets the start time and
saves a pointer to the skb into the appropriate index. The function marks
the in_use bit first before doing any of these steps. The IRQ handler which
clears the timestamps reads the in_use bits uses a lockless flow for
reading the in_use bits to determine which ones are in-use. This is
necessary as actually processing a complete timestamp must be able to sleep
so we cannot hold the timestamp tracker lock over the entire sequence.
Additionally, blocking the Tx hotpath with such a lock indefinitely would
be problematic.
However, the existing flow now has a very narrow window where the IRQ
handler could see a timestamp as in-use but read a stale value for its
"start" time.
Fix this by ordering the sequence to mark the in_use bit last, and add a
memory barrier to prevent re-ordering of the previous writes to setup the
index.
This was found and reported by Sashiko while reviewing an unrelated change.
Closes: https://sashiko.dev/#/patchset/20260821-jk-e825c-minimized-fixes-v1-0-9d0731eb4858%40intel.com?part=7
Fixes: ea9b847cda64 ("ice: enable transmit timestamps for E810 devices")
Signed-off-by: Jacob Keller <jacob.e.keller@intel.com>
---
drivers/net/ethernet/intel/ice/ice_ptp.c | 9 +++++++--
1 file changed, 7 insertions(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/intel/ice/ice_ptp.c b/drivers/net/ethernet/intel/ice/ice_ptp.c
index 2bb9beb94806..1bcc78d08d2f 100644
--- a/drivers/net/ethernet/intel/ice/ice_ptp.c
+++ b/drivers/net/ethernet/intel/ice/ice_ptp.c
@@ -592,6 +592,9 @@ static void ice_ptp_process_tx_tstamp(struct ice_ptp_tx *tx)
bool drop_ts = !link_up;
struct sk_buff *skb;
+ /* Prevent speculative re-ordering of start and skb */
+ smp_rmb();
+
/* Drop packets which have waited for more than 2 seconds */
if (time_is_before_jiffies(tx->tstamps[idx].start + 2 * HZ)) {
drop_ts = true;
@@ -2677,11 +2680,13 @@ s8 ice_ptp_request_ts(struct ice_ptp_tx *tx, struct sk_buff *skb)
* a reference to the skb and the start time to allow discarding old
* requests.
*/
- set_bit(idx, tx->in_use);
- clear_bit(idx, tx->stale);
tx->tstamps[idx].start = jiffies;
tx->tstamps[idx].skb = skb_get(skb);
skb_shinfo(skb)->tx_flags |= SKBTX_IN_PROGRESS;
+ clear_bit(idx, tx->stale);
+ /* Ensure index is setup before marking it as used */
+ smp_mb__before_atomic();
+ set_bit(idx, tx->in_use);
ice_trace(tx_tstamp_request, skb, idx);
}
--
2.56.0.rc0.395.gd1f3524e15dc
next prev parent reply other threads:[~2026-09-22 18:08 UTC|newest]
Thread overview: 23+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-09-22 18:02 [PATCH iwl-net v2 00/15] ice: E82x: timestamp processing logic fixes Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 01/15] ice: use reference counting and SRCU for PTP port access Jacob Keller
2026-09-23 9:47 ` Loktionov, Aleksandr
2026-09-23 20:28 ` Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 02/15] ice: fix PHY port restart serialization Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 03/15] ice: fix removal of PTP timestamp tracker during reset Jacob Keller
2026-09-22 18:02 ` Jacob Keller [this message]
2026-09-22 18:02 ` [PATCH iwl-net v2 05/15] ice: E822: keep Tx timestamps disabled during offset calibration Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 06/15] ice: E822: flush offset verification work during reset preparation Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 07/15] ice: call PTP link change only from link events Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 08/15] ice: E825: stop clearing PHY_REG_TX_OFFSET_READY Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 09/15] ice: E825: clear PHY_REG_TX_MEMORY_STATUS prior to soft reset Jacob Keller
2026-09-23 9:41 ` Loktionov, Aleksandr
2026-09-23 20:28 ` Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 10/15] ice: E825: perform a soft reset when starting the PHY timer Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 11/15] ice: wait for in-flight Tx timestamps before flushing the tracker Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 12/15] ice: keep Tx timestamp slots tracked until completion or timeout Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 13/15] ice: skip reading Tx ready bitmap on ports with no timestamps Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 14/15] ice: don't clear in_use until HW clears ready bitmap Jacob Keller
2026-09-22 18:02 ` [PATCH iwl-net v2 15/15] ice: Recalibrate PHY after settime64 on E825-C Jacob Keller
2026-09-22 18:22 ` [PATCH iwl-net v2 00/15] ice: E82x: timestamp processing logic fixes Jakub Kicinski
2026-09-23 20:31 ` Jacob Keller
2026-09-24 1:05 ` Jacob Keller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20260922-jk-e825c-timestamp-processing-logic-fixes-srcu-v2-4-e55b692d0e6b@intel.com \
--to=jacob.e.keller@intel.com \
--cc=anthony.l.nguyen@intel.com \
--cc=arkadiusz.kubalewski@intel.com \
--cc=grzegorz.nitka@intel.com \
--cc=intel-wired-lan@lists.osuosl.org \
--cc=maciej.machnikowski@intel.com \
--cc=netdev@vger.kernel.org \
--cc=przemyslaw.korba@intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.