[PATCH ath-current 2/2] wifi: ath9k_htc: start ANI when an AP interface begins to beacon

[Mehmet Fide <mehmet.fide@gmail.com>]

From: Mehmet Fide <mehmet.fide@screeningeagle.com>

ath9k_htc_vif_reconfig() re-arms ANI after a channel change when an AP
interface beacons. mac80211 configures the channel before it enables
the beacon, so during a normal AP start that never triggers, and the
start from add_interface that the previous patch removed was cancelled
by the same channel configuration: with hostapd, ANI and the periodic
calibration it drives did not run in AP mode until a later channel
change.

Start ANI when the beacon is enabled. The channel and its calibration
data are in place by then, which is the state vif_reconfig() re-arms
it in, and remove_interface() already stops it with the last AP
interface.

Fixes: a236254c35f0 ("ath9k_htc: Add ANI for AP mode")
Signed-off-by: Mehmet Fide <mehmet.fide@screeningeagle.com>
---
 drivers/net/wireless/ath/ath9k/htc_drv_main.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/net/wireless/ath/ath9k/htc_drv_main.c b/drivers/net/wireless/ath/ath9k/htc_drv_main.c
index a86dd28b0ab7..6578114a4019 100644
--- a/drivers/net/wireless/ath/ath9k/htc_drv_main.c
+++ b/drivers/net/wireless/ath/ath9k/htc_drv_main.c
@@ -1551,6 +1551,9 @@ static void ath9k_htc_bss_info_changed(struct ieee80211_hw *hw,
 		ath9k_htc_set_tsfadjust(priv, vif);
 		priv->cur_beacon_conf.enable_beacon = 1;
 		ath9k_htc_beacon_config(priv, vif);
+		if (priv->ah->opmode == NL80211_IFTYPE_AP &&
+		    !test_bit(ATH_OP_ANI_RUN, &common->op_flags))
+			ath9k_htc_start_ani(priv);
 	}
 
 	if ((changed & BSS_CHANGED_BEACON_ENABLED) && !bss_conf->enable_beacon) {
-- 
2.55.0