From: Andrew Morton <akpm@linux-foundation.org>
To: mm-commits@vger.kernel.org,joseph.qi@linux.alibaba.com,
akpm@linux-foundation.org
Subject: + ocfs2-check-dinode-nlink-and-mode-in-online-filecheck.patch added to mm-nonmm-unstable branch
Date: Mon, 09 Nov 2026 12:53:25 -0800 [thread overview]
Message-ID: <20261109205325.B38A21F0089F@smtp.kernel.org> (raw)
The patch titled
Subject: ocfs2: check dinode nlink and mode in online filecheck
has been added to the -mm mm-nonmm-unstable branch. Its filename is
ocfs2-check-dinode-nlink-and-mode-in-online-filecheck.patch
This patch will shortly appear at
https://git.kernel.org/pub/scm/linux/kernel/git/akpm/25-new.git/tree/patches/ocfs2-check-dinode-nlink-and-mode-in-online-filecheck.patch
This patch will later appear in the mm-nonmm-unstable branch at
git://git.kernel.org/pub/scm/linux/kernel/git/akpm/mm
Before you just go and hit "reply", please:
a) Consider who else should be cc'ed
b) Prefer to cc a suitable mailing list as well
c) Ideally: find the original patch on the mailing list and do a
reply-to-all to that, adding suitable additional cc's
*** Remember to use Documentation/process/submit-checklist.rst when testing your code ***
The -mm tree is included into linux-next via various
branches at git://git.kernel.org/pub/scm/linux/kernel/git/akpm/mm
and is updated there most days
------------------------------------------------------
From: Joseph Qi <joseph.qi@linux.alibaba.com>
Subject: ocfs2: check dinode nlink and mode in online filecheck
Date: Mon, 09 Nov 2026 20:21:13 +0800
The filecheck validator shares most of its conditions with
ocfs2_validate_inode_block(), but skips the zero nlink or mode check.
Wire it in using the predicate the two now share.
Filecheck reports OCFS2_FILECHECK_ERR_INVALIDINO and logs with the
Filecheck prefix rather than calling ocfs2_error(), which would escalate
to ocfs2_handle_error() and could force the filesystem read-only while
an administrator is only asking for a diagnosis.
The check is placed after the ecc and signature gate so that the
existing coupling is preserved: a bad signature still overrides a
checksum failure with INVALIDINO, and every later check still runs only
on an ecc-clean block.
Link: https://lore.kernel.org/20261109122121.21473-24-joseph.qi@linux.alibaba.com
Signed-off-by: Joseph Qi <joseph.qi@linux.alibaba.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Cc: Heming Zhao <heming.zhao@suse.com>
Cc: Mark Fasheh <mark@fasheh.com>
Cc: Joel Becker <jlbec@evilplan.org>
---
fs/ocfs2/inode.c | 9 +++++++++
1 file changed, 9 insertions(+)
--- a/fs/ocfs2/inode.c~ocfs2-check-dinode-nlink-and-mode-in-online-filecheck
+++ a/fs/ocfs2/inode.c
@@ -2020,6 +2020,15 @@ static int ocfs2_filecheck_validate_inod
goto bail;
}
+ if (ocfs2_dinode_has_zero_nlink_or_mode(di)) {
+ mlog(ML_ERROR,
+ "Filecheck: invalid dinode #%llu: nlink = %u or mode = %u\n",
+ (unsigned long long)bh->b_blocknr,
+ ocfs2_read_links_count(di), le16_to_cpu(di->i_mode));
+ rc = -OCFS2_FILECHECK_ERR_INVALIDINO;
+ goto bail;
+ }
+
if (!ocfs2_valid_inode_mode(le16_to_cpu(di->i_mode))) {
mlog(ML_ERROR,
"Filecheck: invalid dinode #%llu: mode 0%o has unknown file type\n",
_
Patches currently in -mm which might be from joseph.qi@linux.alibaba.com are
ocfs2-exempt-orphaned-dinodes-from-the-zero-nlink-check.patch
ocfs2-abstract-the-zero-nlink-or-mode-dinode-check.patch
ocfs2-abstract-the-dinode-i_blkno-mismatch-check.patch
ocfs2-abstract-the-dinode-ocfs2_valid_fl-check.patch
ocfs2-abstract-the-dinode-fs_generation-mismatch-check.patch
ocfs2-abstract-the-dinode-suballoc-slot-checks.patch
ocfs2-abstract-the-dinode-suballoc-bit-check.patch
ocfs2-abstract-the-dinode-orphaned-slot-check.patch
ocfs2-abstract-the-dinode-dio-orphaned-slot-check.patch
ocfs2-abstract-the-inline-data-dinode-guard-and-cluster-check.patch
ocfs2-abstract-the-inline-data-id_count-bound-check.patch
ocfs2-abstract-the-inline-data-i_size-bound-check.patch
ocfs2-abstract-the-fast-symlink-dinode-guard-and-size-check.patch
ocfs2-abstract-the-fast-symlink-nul-termination-check.patch
ocfs2-abstract-the-chain-list-dinode-guard-and-count-check.patch
ocfs2-abstract-the-chain-list-next-free-record-check.patch
ocfs2-abstract-the-chain-list-bits-per-cluster-check.patch
ocfs2-abstract-the-dinode-refcount-location-check.patch
ocfs2-abstract-the-zero-extent-list-count-check.patch
ocfs2-abstract-the-oversized-extent-list-count-check.patch
ocfs2-abstract-the-extent-list-next-free-record-check.patch
ocfs2-report-unrepairable-corruption-from-online-filecheck-fix.patch
ocfs2-check-dinode-nlink-and-mode-in-online-filecheck.patch
ocfs2-check-dinode-suballoc-slot-in-online-filecheck.patch
ocfs2-check-dinode-suballoc-bit-in-online-filecheck.patch
ocfs2-check-dinode-orphaned-slots-in-online-filecheck.patch
ocfs2-check-inline-data-dinodes-in-online-filecheck.patch
ocfs2-check-fast-symlink-dinodes-in-online-filecheck.patch
ocfs2-check-chain-list-dinodes-in-online-filecheck.patch
ocfs2-check-dinode-refcount-location-in-online-filecheck.patch
ocfs2-check-extent-list-dinodes-in-online-filecheck.patch
reply other threads:[~2026-11-09 20:53 UTC|newest]
Thread overview: [no followups] expand[flat|nested] mbox.gz Atom feed
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20261109205325.B38A21F0089F@smtp.kernel.org \
--to=akpm@linux-foundation.org \
--cc=joseph.qi@linux.alibaba.com \
--cc=mm-commits@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.