Re: [PATCH] can: virtio: fix virtqueue use before DRIVER_OK

["Michael S. Tsirkin" <mst@redhat.com>]

On Wed, Nov 11, 2026 at 02:11:13AM +0900, Seonghyeon Lim via B4 Relay wrote:
> From: Seonghyeon Lim <forfortuna@naver.com>
> 
> virtio_can_probe() and virtio_can_restore() fill the RX virtqueue and
> kick it before the device is set DRIVER_OK. The virtio specification
> does not allow the driver to notify the device before DRIVER_OK.
> 
> In restore, if the interface was up, virtio_can_open() then sends a
> START control message and waits for the reply. DRIVER_OK is only set
> by the virtio core after restore returns, so the device may never
> handle the request and the wait never completes, which hangs system
> resume. In probe, an ndo_open() right after register_candev() can
> likewise send the START message before DRIVER_OK.
> 
> Call virtio_device_ready() before the first virtqueue use in both
> probe and restore, as virtio-net does.
> 
> Fixes: 083082a4e6d8 ("can: virtio: Add virtio CAN driver")
> Signed-off-by: Seonghyeon Lim <forfortuna@naver.com>

however, device ready means you can get callbacks: config
and vq.


did you audit the driver to make sure this is safe while
probe did not yet populate and register the device?

> ---

> Tested with QEMU 8.2 + vhost-device-can: with the CAN interface up,
> suspend/resume (pm_test=devices) hangs without this patch and
> completes with it. No new lockdep warnings.
> ---
>  drivers/net/can/virtio_can.c | 6 ++++++
>  1 file changed, 6 insertions(+)
> 
> diff --git a/drivers/net/can/virtio_can.c b/drivers/net/can/virtio_can.c
> index f67d0bf09681..ae35a00b784b 100644
> --- a/drivers/net/can/virtio_can.c
> +++ b/drivers/net/can/virtio_can.c
> @@ -912,6 +912,9 @@ static int virtio_can_probe(struct virtio_device *vdev)
>  		err = -ENOMEM;
>  		goto on_failure;
>  	}
> +
> +	virtio_device_ready(vdev);
> +
>  	virtio_can_populate_rx_vq(vdev);
>  
>  	err = register_virtio_can_dev(dev);
> @@ -966,6 +969,9 @@ static int __maybe_unused virtio_can_restore(struct virtio_device *vdev)
>  		virtio_can_del_vq(vdev);
>  		return -ENOMEM;
>  	}
> +
> +	virtio_device_ready(vdev);
> +
>  	virtio_can_populate_rx_vq(vdev);
>  
>  	if (netif_running(ndev)) {
> 
> ---
> base-commit: ddfe51b0a0f5dc9e415cc2c8ad8db17532dd426b
> change-id: 20261111-virtio-can-ready-85cefff06a84
> 
> Best regards,
> --  
> Seonghyeon Lim <forfortuna@naver.com>
>