Re: [PATCH] smsc95xx: support ethtool get_regs

["Émeric Vigier" <emeric.vigier@savoirfairelinux.com>]

----- Mail original -----
> Émeric Vigier <emeric.vigier@savoirfairelinux.com> :
> [...]
> > Yes, there are 16 bits wide according to smsc95xx.h.
> > But other smsc drivers define 32bit wide PHY regs. I made myself
> > believe
> > that smsc would use the same PHY for each ethernet chip.
> 
> SMSC people would surely answer before I find the relevant datasheet.
> 
> Anyway the PHY registers are accessed indirectly through the
> MII_{ADDR, DATA}
> registers and MII_DATA r/w mask is limited to the lower 16 bits.
> 
> > So would something like s/32 * sizeof(u32)/PHY_SPECIAL *
> > sizeof(u16)/ solve the issue here?
> 
> You would have to pack data[] as well. Or use u16 *.

I will check this out next week.

> 
> > Concerning the ioctl, I found ethtool much easier to use. And I
> > believe
> > smsc9514 is a very popular chipset, so this could help others
> > debugging it.
> 
> # mii-tool -vv e1000
> Using SIOCGMIIPHY=0x8947
> e1000: no autonegotiation, 10baseT-HD, link ok
>   registers for MII PHY 0:
>     1140 796d 0141 0c30 0de1 0021 0004 0000
>     0000 0200 0000 0000 0000 0000 0000 3000
>     0000 0000 0000 0000 0174 0000 0000 0000
>     4100 0000 000d 000f 0000 0000 0000 0000
>   product info: vendor 00:50:43, model 3 rev 0
>   basic mode:   autonegotiation enabled
>   basic status: autonegotiation complete, link ok
>   capabilities: 1000baseT-FD 100baseTx-FD 100baseTx-HD 10baseT-FD
>   10baseT-HD
>   advertising:  1000baseT-FD 100baseTx-FD 100baseTx-HD 10baseT-FD
>   10baseT-HD flow-control
>   link partner: 10baseT-HD
> 
> It is not that bad for the first 32 PHY registers.

I didn't know about mii-tool. Thanks.

> 
> [...]
> > Do you mean LTT? I am not familiar with it, I should have a look.
> 
> Documentation/trace/ftrace.txt

ok

> 
> [...]
> > I should change that in previous "for" loop as well I suppose?
> 
> You may.

Thanks for your patience.

> 
> --
> Ueimor
> 

-- 
Emeric