From: "Zhenyu Wu" <y030729@njupt.edu.cn>
To: rol@as2917.net
Cc: linux-kernel@vger.kernel.org
Subject: Re: ARP routing issue
Date: Fri, 07 Jan 2005 09:29:46 +0800 [thread overview]
Message-ID: <305061386.22926@njupt.edu.cn> (raw)
I met a question about ARP. If i send packet to another host using Raw socket at
one host and i set protocol type into TCP, then at another host i receive the
packet, but when i read the field skb->protocol, it is ARP. But when i changed a
host to send the packet, it does well.
There are something wrong on my network card or the Kernel?
>Hello,
>
> Have a look at /proc/sys/net/conf/XXX/arp_filter :
>
>
> arp_filter - BOOLEAN
> 1 - Allows you to have multiple network interfaces on the same
> subnet, and have the ARPs for each interface be answered
> based on whether or not the kernel would route a packet from
> the ARP'd IP out that interface (therefore you must use source
> based routing for this to work). In other words it allows control
> of which cards (usually 1) will respond to an arp request.
>
> 0 - (default) The kernel can respond to arp requests with addresses
> from other interfaces. This may seem wrong but it usually makes
> sense, because it increases the chance of successful communication.
> IP addresses are owned by the complete host on Linux, not by
> particular interfaces. Only for more complex setups like load-
> balancing, does this behaviour cause problems.
>
> Regards,
> Paul
>
> Paul Rolland, rol(at)as2917.net
> ex-AS2917 Network administrator and Peering Coordinator
>
> --
>
> Please no HTML, I'm not a browser - Pas d'HTML, je ne suis pas un navigateur
>
> "Some people dream of success... while others wake up and work hard at it"
>
>
>
> > -----Message d'origine-----
> > De : linux-kernel-owner@vger.kernel.org
> > [mailto:linux-kernel-owner@vger.kernel.org] De la part de Jan De Luyck
> > Envoy?: jeudi 6 janvier 2005 17:12
> > ?: Steve Iribarne
> > Cc : linux-kernel@vger.kernel.org; linux-net@vger.kernel.org
> > Objet : Re: ARP routing issue
> >
> > On Thursday 06 January 2005 17:06, Steve Iribarne wrote:
> > > Hi Jan,
> > >
> > >
> > > -> default gateway is set to 10.0.22.1, on eth0.
> > > ->
> > > -> Problem is, if I try to ping from another network
> > > -> (10.216.0.xx) to 10.0.24.xx, i see the following ARP request:
> > > ->
> > > -> arp who-has 10.0.22.1 tell 10.0.24.xx
> > > ->
> > >
> > > You see that coming out the eth0 interface??
> > >
> > > If that is the case it is most definately wrong. Assuming that your
> > > masks are setup properly. But I haven't worked on the 2.4
> > kernel for a
> > > long time so I'm not so sure if what you are seeing is a
> > bug that has
> > > been fixed.
> >
> > The network information is:
> > eth0 10.0.22.xxx mask 255.255.255.0
> > eth1 10.0.24.xxx mask 255.255.255.0
> >
> > routing:
> > 10.0.22.0 0.0.0.0 255.255.255.0 eth0
> > 10.0.24.0 0.0.0.0 255.255.255.0 eth1
> > 0.0.0.0 10.0.22.1 0.0.0.0 eth0
> >
> > Jan
> >
> > --
> > If a man slept by day, he had little time to work. That was a
> > satisfying notion to Escargot.
> > -- "The Stone Giant", James P. Blaylock
> > -
> > To unsubscribe from this list: send the line "unsubscribe
> > linux-kernel" in
> > the body of a message to majordomo@vger.kernel.org
> > More majordomo info at http://vger.kernel.org/majordomo-info.html
> > Please read the FAQ at http://www.tux.org/lkml/
> >
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/
>
next reply other threads:[~2005-01-07 0:42 UTC|newest]
Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top
2005-01-07 1:29 Zhenyu Wu [this message]
-- strict thread matches above, loose matches on Subject: below --
2005-01-06 17:51 ARP routing issue Steve Iribarne
2005-01-06 17:57 ` Jan De Luyck
2005-01-06 16:06 Steve Iribarne
2005-01-06 16:11 ` Jan De Luyck
2005-01-06 17:53 ` Paul Rolland
2005-01-06 17:57 ` Jan De Luyck
2005-01-14 22:47 ` James Courtier-Dutton
2005-01-15 12:31 ` Jan De Luyck
2005-01-15 22:51 ` Alan Cox
2005-01-06 15:47 Jan De Luyck
2005-01-06 17:51 ` Alan Cox
2005-01-07 6:49 ` Jan De Luyck
2005-01-07 7:44 ` Julian Anastasov
2005-01-07 8:06 ` Jan De Luyck
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=305061386.22926@njupt.edu.cn \
--to=y030729@njupt.edu.cn \
--cc=linux-kernel@vger.kernel.org \
--cc=rol@as2917.net \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.