From: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
To: Javier Martinez Canillas <javier@osg.samsung.com>
Cc: linux-kernel@vger.kernel.org, devicetree@vger.kernel.org,
Mauro Carvalho Chehab <mchehab@osg.samsung.com>,
Enrico Butera <ebutera@gmail.com>,
Sakari Ailus <sakari.ailus@linux.intel.com>,
Enric Balletbo i Serra <eballetbo@gmail.com>,
Rob Herring <robh+dt@kernel.org>,
Eduard Gavin <egavinc@gmail.com>,
Hans Verkuil <hans.verkuil@cisco.com>,
linux-media@vger.kernel.org
Subject: Re: [PATCH 07/10] [media] tvp5150: Add device tree binding document
Date: Wed, 06 Jan 2016 13:00:31 +0200 [thread overview]
Message-ID: <3433197.yOemOv0bmo@avalon> (raw)
In-Reply-To: <568CF08B.6080107@osg.samsung.com>
On Wednesday 06 January 2016 07:46:35 Javier Martinez Canillas wrote:
> On 01/06/2016 07:39 AM, Laurent Pinchart wrote:
> > Hi Javier,
> >
> > Thank you for the patch.
>
> Thanks a lot for your feedback.
>
> [snip]
>
> >> +
> >> +Optional Properties:
> >> +- powerdown-gpios: phandle for the GPIO connected to the PDN pin, if
> >> any.
> >
> > The signal is called PDN in the datasheet, so it might make sense to call
> > this pdn-gpios. I have no strong opinion on this, I'll let you decide
> > what you think is best.
>
> Yes, I wondered if the convention was to use a descriptive name or the one
> used in the datasheet but Documentation/devicetree/bindings/gpio/gpio.txt
> says nothing about it.
The device tree maintainers might want to comment on that :-)
> I'll change it to pdn-gpios since it could be easier to match with the doc.
--
Regards,
Laurent Pinchart
next prev parent reply other threads:[~2016-01-06 11:00 UTC|newest]
Thread overview: 36+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-01-04 12:25 [PATCH 00/10] [media] tvp5150: add MC and DT support Javier Martinez Canillas
2016-01-04 12:25 ` Javier Martinez Canillas
2016-01-04 12:25 ` [PATCH 01/10] [media] tvp5150: Restructure version detection Javier Martinez Canillas
2016-01-04 12:25 ` [PATCH 02/10] [media] tvp5150: Add tvp5151 support Javier Martinez Canillas
2016-01-04 12:25 ` [PATCH 03/10] [media] tvp5150: Add pad-level subdev operations Javier Martinez Canillas
2016-01-04 12:25 ` [PATCH 04/10] [media] tvp5150: Add pixel rate control support Javier Martinez Canillas
2016-01-04 12:25 ` [PATCH 05/10] [media] tvp5150: Add s_stream subdev operation support Javier Martinez Canillas
2016-01-04 12:25 ` [PATCH 06/10] [media] tvp5150: Add g_mbus_config " Javier Martinez Canillas
2016-01-04 12:25 ` [PATCH 07/10] [media] tvp5150: Add device tree binding document Javier Martinez Canillas
[not found] ` <1451910332-23385-8-git-send-email-javier-JPH+aEBZ4P+UEJcrhfAQsw@public.gmane.org>
2016-01-04 14:07 ` Rob Herring
2016-01-04 14:07 ` Rob Herring
2016-01-04 16:16 ` Javier Martinez Canillas
2016-01-04 16:16 ` Javier Martinez Canillas
2016-01-06 10:39 ` Laurent Pinchart
2016-01-06 10:39 ` Laurent Pinchart
2016-01-06 10:46 ` Javier Martinez Canillas
2016-01-06 11:00 ` Laurent Pinchart [this message]
2016-01-04 12:25 ` [PATCH 08/10] [media] tvp5150: Add OF match table Javier Martinez Canillas
2016-01-06 10:40 ` Laurent Pinchart
2016-01-04 12:25 ` [PATCH 09/10] [media] tvp5150: Initialize the chip on probe Javier Martinez Canillas
[not found] ` <1451910332-23385-10-git-send-email-javier-JPH+aEBZ4P+UEJcrhfAQsw@public.gmane.org>
2016-01-04 12:40 ` kbuild test robot
2016-01-04 12:40 ` kbuild test robot
[not found] ` <201601042006.Dk9Wav4W%fengguang.wu-ral2JQCrhuEAvxtiuMwx3w@public.gmane.org>
2016-01-04 12:53 ` Javier Martinez Canillas
2016-01-04 12:53 ` Javier Martinez Canillas
2016-01-06 10:59 ` Laurent Pinchart
2016-01-06 10:59 ` Laurent Pinchart
2016-01-06 11:39 ` Javier Martinez Canillas
2016-01-06 11:39 ` Javier Martinez Canillas
2016-01-04 12:25 ` [PATCH 10/10] [media] tvp5150: Configure data interface via pdata or DT Javier Martinez Canillas
2016-01-06 10:56 ` Laurent Pinchart
2016-01-06 11:27 ` Javier Martinez Canillas
2016-01-06 11:27 ` Javier Martinez Canillas
[not found] ` <568CFA1E.6060309-JPH+aEBZ4P+UEJcrhfAQsw@public.gmane.org>
2016-01-06 13:48 ` Laurent Pinchart
2016-01-06 13:48 ` Laurent Pinchart
2016-01-06 15:04 ` Javier Martinez Canillas
2016-01-06 15:04 ` Javier Martinez Canillas
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=3433197.yOemOv0bmo@avalon \
--to=laurent.pinchart@ideasonboard.com \
--cc=devicetree@vger.kernel.org \
--cc=eballetbo@gmail.com \
--cc=ebutera@gmail.com \
--cc=egavinc@gmail.com \
--cc=hans.verkuil@cisco.com \
--cc=javier@osg.samsung.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-media@vger.kernel.org \
--cc=mchehab@osg.samsung.com \
--cc=robh+dt@kernel.org \
--cc=sakari.ailus@linux.intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.