Re: Help with cd writing scsi error?

[Simon Piette <spiette@generation.net>]

Jerry Quinn wrote:
> 
> Hi all.  I'm trying to burn an audio CD on a stock kernel.org 2.2.10 kernel on
> a Powercenter (R5 dist).  The generic SCSI driver is built as a module.  I'm
> using cdrecord-1.8a24, the latest I could find (1.8a21 gives the same error).
> I'm setting shmmax to 16M.  My burner is a Panasonic CW-7502 with rev 4.17
> firmware.
> 
> Basic info gathering from the drive seems to work fine.  I can extract digital
> audio as well.  I pulled one track off a disc to use as a writing test.  To do
> the test I try the following with a CDR blank in the drive:
> 
> cdrecord dev=3,0 -dummy -audio track.wav
> 
> I get the following error -
> 
> cdrecord Input/output error.  read track info: scsi sendcmd: retryable error
> CDB: 52 01 00 00 00 FF 00 00 1C 00
> status: 0x2 (CHECK CONDITION)
> Sense Bytes: 70 00 05 00 00 00 0A 00 00 00 00 64 00 00 00
> Sense Key: 0x5 Illegal Request, Segment 0
> Sense Code: 0x64 Qual 0x00 (illegal mode for this track) Fru 0x0
> Sense flags: Blk 0 (not valid)
> cmd finished after 0.003s timeout 240s
> 
> cdrecord says it is using generic SCSI-3/mmc cdr driver (mmc_cdr) and driver
> flags are SWABAUDIO.
> 
> Any ideas?

Could you try :

$ cdrecord dev=3,0,0 fs=3800k -dummy -audio track.wav 

Arguments for dev: bus, id, lun

Have you 3 scsi buses and your cd-burner is at id 0 on your last
detected bus? 


Simon

[[ This message was sent via the linuxppc-dev mailing list.  Replies are ]]
[[ not  forced  back  to the list, so be sure to Cc linuxppc-dev if your ]]
[[ reply is of general interest. Please check http://lists.linuxppc.org/ ]]
[[ and http://www.linuxppc.org/ for useful information before posting.   ]]