Hello,everyone.
I'm trying to make the SCC1 drived rs232 port of a motorola
mpc8260 ads board work.The manual says it can direct connect
to pc com port.But it seems the output from this board is not
rs232 voltage.i.e -3 to -12 for logical one,3 to 12 for logical
zero,nor is it TTL,it seems that it use 0 for logical 1,5.0v for
logical 0,so it is rather annoying. I have to invert the output
from 8260 ads,then use a TTL->232 converter to connect with PC,
it works when i send char from 8260,but cannot work in the
other direction.
In addition,for a while,it output 232 signal,but i cannot
reproduce it!!
Does anyone has experience with this board?
Thanks for your advice.
                    davidzhang
                    3/22/2000

_____________________________________________
首都在线--中国人的网上家园 http://www.263.net
@263.net中国最大的在线邮局 http://freemail.263.net

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/