From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id ; Wed, 21 Feb 2001 20:33:25 -0500 Received: (majordomo@vger.kernel.org) by vger.kernel.org id ; Wed, 21 Feb 2001 20:33:04 -0500 Received: from dfw-smtpout3.email.verio.net ([129.250.36.43]:50060 "EHLO dfw-smtpout3.email.verio.net") by vger.kernel.org with ESMTP id ; Wed, 21 Feb 2001 20:32:56 -0500 Message-ID: <3A931AD8.53FD2EA1@nospam.org> Date: Tue, 20 Feb 2001 17:33:12 -0800 From: Tim Moore Organization: Yoyodyne Propulsion Systems, Inc. X-Mailer: Mozilla 4.75 [en] (X11; U; Linux 2.2.19pre8+IDE i686) X-Accept-Language: en MIME-Version: 1.0 To: linux-kernel Subject: Re: 2.2.17 Lockup and ATA-66/100 forced bit set (WARNING) In-Reply-To: <20010221173439.A3178@angus.foo.net> Content-Type: text/plain; charset=us-ascii Content-Transfer-Encoding: 7bit Sender: linux-kernel-owner@vger.kernel.org X-Mailing-List: linux-kernel@vger.kernel.org > I've enabled the higher performance features for my ATA drive by getting > 2.2.17, applying Andre Hendrick's IDE patch, adding: > append="idebus=66 ide0=ata66" > to lilo.conf. I was told that Alan's patches from here: > should be used. Is this true if I used Andre's patch? Is the warning > message in my bootlog anything to worry about? The board is an ABIT KT7A > w/ KT133A chipset. Alan = kernel, Andre = IDE. 2.2.18 (kernel) + ide.2.2.18.1221 (IDE patch) + 2.2.19pre8 (kernel patch). See samples below. > Also, the machine locked up once (hard, couldn't connect via network). I > am using the Matrox G450 beta driver with XF 4.0.2 though. Maybe that > was the cause? Ensoniq AudioPCI (ES1370) was problematic if I tried to assign IRQ5 on the KA7 (hard trailess lockups, all IRQ's migrated to 10 or 11 regardless of config, digital audio ScreamOfAgony), whereas IRQ 3 worked fine. Similar experiements with Intel chipset boards P3B-F & BP6 suffer no such issues so I assume it's VT82C686/ES1370 specific. Abit KA7, 2.2.19pre8 + ide.2.2.18.1221 -------------------------------------- Linux version 2.2.19pre8+IDE (root@abit) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #6 Tue Feb 20 01:14:30 PST 2001 USER-provided physical RAM map: USER: 0009f000 @ 00000000 (usable) USER: 1ff00000 @ 00100000 (usable) Detected 800063 kHz processor. ide_setup: idebus=33 ide_setup: ide0=ata66 ide_setup: ide1=ata66 Console: colour VGA+ 80x25 Calibrating delay loop... 1595.80 BogoMIPS Memory: 517204k/524288k available (1116k kernel code, 412k reserved, 5508k data, 48k init) Dentry hash table entries: 65536 (order 7, 512k) Buffer cache hash table entries: 524288 (order 9, 2048k) Page cache hash table entries: 131072 (order 7, 512k) CPU: L1 I Cache: 64K L1 D Cache: 64K CPU: L2 Cache: 512K CPU: AMD Athlon(tm) Processor stepping 02 Checking 386/387 coupling... OK, FPU using exception 16 error reporting. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.35a (19990819) Richard Gooch (rgooch@atnf.csiro.au) PCI: PCI BIOS revision 2.10 entry at 0xfb4d0 PCI: Probing PCI hardware ... Uniform Multi-Platform E-IDE driver Revision: 6.30 ide: Assuming 33MHz system bus speed for PIO modes VP_IDE: IDE controller on PCI bus 00 dev 39 VP_IDE: chipset revision 16 VP_IDE: not 100% native mode: will probe irqs later VT 8371 Chipset Core ATA-66 VP_IDE: ATA-66/100 forced bit set (WARNING)!! Split FIFO Configuration: 8 Primary buffers, threshold = 1/2 8 Second. buffers, threshold = 1/2 ide0: BM-DMA at 0xd000-0xd007, BIOS settings: hda:DMA, hdb:DMA ide0: VIA Bus-Master (U)DMA Timing Config Success VP_IDE: ATA-66/100 forced bit set (WARNING)!! ide1: BM-DMA at 0xd008-0xd00f, BIOS settings: hdc:DMA, hdd:DMA ide1: VIA Bus-Master (U)DMA Timing Config Success hda: IBM-DTLA-307020, ATA DISK drive hdb: YAMAHA CRW4416E, ATAPI CDROM drive hdc: IBM-DTLA-307020, ATA DISK drive hdd: HP COLORADO 20GB, ATAPI TAPE drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: IBM-DTLA-307020, 19623MB w/1916kB Cache, CHS=2501/255/63, UDMA(66) hdc: IBM-DTLA-307020, 19623MB w/1916kB Cache, CHS=39870/16/63, UDMA(66) ... # lspci -v 00:00.0 Host bridge: VIA Technologies, Inc.: Unknown device 0391 (rev 02) Flags: bus master, medium devsel, latency 0 Memory at d0000000 (32-bit, prefetchable) Capabilities: [a0] AGP version 2.0 00:01.0 PCI bridge: VIA Technologies, Inc.: Unknown device 8391 (prog-if 00 [Normal decode]) Flags: bus master, 66Mhz, medium devsel, latency 0 Bus: primary=00, secondary=01, subordinate=01, sec-latency=0 Memory behind bridge: d2000000-d3ffffff Prefetchable memory behind bridge: d4000000-d5ffffff Capabilities: [80] Power Management version 2 00:07.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super] (rev 22) Subsystem: VIA Technologies, Inc.: Unknown device 0000 Flags: bus master, stepping, medium devsel, latency 0 00:07.1 IDE interface: VIA Technologies, Inc. VT82C586 IDE [Apollo] (rev 10) (prog-if 8a [Master SecP PriP]) Flags: bus master, medium devsel, latency 32 I/O ports at d000 Capabilities: [c0] Power Management version 2 00:07.4 Host bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 30) Flags: medium devsel Capabilities: [68] Power Management version 2 Generic Socket7, 2.2.19pre8 + ide.2.2.18.1221 --------------------------------------------- Linux version 2.2.19pre8+IDE (root@localhost.localdomain) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #3 Mon Feb 19 21:07:58 PST 2001 BIOS-provided physical RAM map: BIOS-e820: 0009f000 @ 00000000 (usable) BIOS-e820: 03f00000 @ 00100000 (usable) Detected 166405 kHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 331.77 BogoMIPS Memory: 63060k/65536k available (1044k kernel code, 412k reserved, 972k data, 48k init) Dentry hash table entries: 8192 (order 4, 64k) Buffer cache hash table entries: 65536 (order 6, 256k) Page cache hash table entries: 16384 (order 4, 64k) CPU: Intel Pentium 75 - 200 stepping 0c Checking 386/387 coupling... OK, FPU using exception 16 error reporting. Checking 'hlt' instruction... OK. Intel Pentium with F0 0F bug - workaround enabled. POSIX conformance testing by UNIFIX PCI: PCI BIOS revision 2.10 entry at 0xfb470 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: 00:38 [1106/0586]: Work around ISA DMA hangs (00) Activating ISA DMA hang workarounds. ... Uniform Multi-Platform E-IDE driver Revision: 6.30 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller on PCI bus 00 dev 39 VP_IDE: chipset revision 2 VP_IDE: not 100% native mode: will probe irqs later ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VT 82C585 Apollo VP1/VPX Chipset Core ATA-33 Split FIFO Configuration: 16 Primary buffers, threshold = 3/4 0 Second. buffers, threshold = 1/2 ide0: BM-DMA at 0x6000-0x6007, BIOS settings: hda:DMA, hdb:DMA ide0: VIA Bus-Master (U)DMA Timing Config Success hda: IBM-DJNA-370910, ATA DISK drive hdb: BCD-F520D CD-ROM, ATAPI CDROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hda: IBM-DJNA-370910, 8693MB w/1966kB Cache, CHS=1108/255/63, (U)DMA ... # lspci -v 00:00.0 Host bridge: VIA Technologies, Inc. VT82C585VP [Apollo VP1/VPX] (rev 10) Flags: bus master, 66Mhz, medium devsel, latency 32 00:07.0 ISA bridge: VIA Technologies, Inc. VT82C586/A/B PCI-to-ISA [Apollo VP] (rev 02) Flags: bus master, medium devsel, latency 0 00:07.1 IDE interface: VIA Technologies, Inc. VT82C586 IDE [Apollo] (rev 02) (prog-if 8a [Master SecP PriP]) Flags: bus master, medium devsel, latency 32 I/O ports at 6000 Memory at e1020000 (32-bit, non-prefetchable) -- timothymoore bigfoot com