From: jheumann@fonts.de
To: parisc-linux@thepuffingroup.com
Subject: [parisc-linux] 0.9ser can't install on D210
Date: Tue, 05 Jun 2001 12:23:14 +0200 [thread overview]
Message-ID: <3B1CB312.1C9DBAB9@fonts.de> (raw)
please help,
i can't load linux pa-risc 0.9seriell on my HP9000/D210.
Why?
(HP-UX 10.20 is running....)
Jan Heumann
jheumann@fonts.de
-----------------------------------------------------
Main Menu: Enter command > search
Searching for potential boot device(s)...
This may take several minutes.
To discontinue search, press any key (termination may not be immediate).
Path Number Device Path (dec) Device Type
----------- ----------------- -----------
P0 4.5 Random access media
P1 4.8 Random access media
P2 16/5.2 Random access media
P3 16/6.0 LAN Module
Main Menu: Enter command > boot p2
Interact with IPL (Y or N)?> n
Booting...
Boot IO Dependent Code (IODC) revision 1
IPL error: bad IPL checksum.
Error Reading IPL
Main Menu: Enter command > search
Searching for potential boot device(s)...
This may take several minutes.
To discontinue search, press any key (termination may not be immediate).
Path Number Device Path (dec) Device Type
----------- ----------------- -----------
P0 4.5 Random access media
P1 4.8 Random access media
P2 16/5.2 Random access media
P3 16/6.0 LAN Module
Main Menu: Enter command > boot p2
Interact with IPL (Y or N)?> y
Booting...
Boot IO Dependent Code (IODC) revision 1
IPL error: bad IPL checksum.
Error Reading IPL
--------------------------------------------------------
information all
PROCESSOR INFORMATION
HVERSION SVERSION CVERSION
Speed Model Model/Op (Revision)
--------- -------- -------- ----------
100 MHz 0x4840 0x0481 12
HSC Bus Speed (in MHz) : 33
Software ID (dec) : 2009187834
Software ID (hex) : 0x77c1c5fa
Software Capability : 0xf0
<Press any key to continue (q to quit)>
COPROCESSOR INFORMATION
Coprocessor Coprocessor Coprocessor
Model Revision State
----------- ----------- -------------
0x0000000d 1 Functional
CACHE INFORMATION
Instruction Cache Size Data Cache Size
----------------------- ---------------
128 KB 128 KB
<Press any key to continue (q to quit)>
MEMORY INFORMATION
Slot Card Size Amount Enabled
---- --------- --------------
0 64 MB 64 MB
1 64 MB 64 MB
2 64 MB 64 MB
3 64 MB 64 MB
4 64 MB 64 MB
5 64 MB 64 MB
Physical Memory: 384 MB (0x18000000)
Configured Memory: 384 MB (0x18000000)
<Press any key to continue (q to quit)>
I/O MODULE INFORMATION
IODC
IODC
Path (dec) Type Slot Mod HVERSION SVERSION Vers
Dep
---- ---- ---- --- -------- ---------- ------
------
4 A DMA I/O 1 0 0x0131 0x00008980 0x07
0x00
16 Bus Adapter 4 0 0x02e0 0x00008100 0x00
0x00
16/4 Built-in RS232 1 0 0x02e0 0x00008c00 0x01
0x00
16/5 Built-in SE SCSI 1 1 0x02e0 0x00008200 0x01
0x00
16/6 Built-in LAN 1 2 0x02e0 0x00008a00 0x02
0x00
16/0 Built-in Parallel 0 0 0x02e0 0x00007400 0x00
0x00
16/7 Built-in Keyboard 1 3 0x02e0 0x00008400 0x00
0x00
16/8 Built-in Mouse 2 0 0x02e0 0x00008400 0x00
0x00
20 Bus Adapter 5 0 0x0300 0x00008e00 0x00
0x00
20/2 RS232 Port 0 2 0x0300 0x00008c00 0x01
0x00
20/5 Bus Adapter 1 1 0x0300 0x00009000 0x00
0x00
<Press any key to continue (q to quit)>
Hot Swap module is present.
EISA Cards
Path Type EISA ID
---- ---- -------
20/5/1 EISA card 0x25d00400
20/5/2 EISA slot is empty
20/5/3 EISA slot is empty
20/5/4 EISA slot is empty
<Press any key to continue (q to quit)>
BOOT INFORMATION
Autoboot: ON
Autosearch: ON
Fastboot: OFF
Primary boot path: 4.8 (dec)
04.8 (hex)
Alternate boot path: 16/5.2 (dec)
10/05.2 (hex)
Console path: 16/4.0 (dec)
10/04.0 (hex)
Keyboard path: 16/7.0 (dec)
10/07.0 (hex)
LAN Station Address: 080009-af13c8
Mon Jan 5 21:15:36 GMT 1970 (19:70:01:05:21:15:36)
<Press any key to continue (q to quit)>
FIRMWARE INFORMATION
Firmware Version: 36.34
CHIP REVISIONS
Module Revision
------ --------
System Board 0
Processor Board 2
PA 7100LC 12
Firmware 20
Fast/Wide SCSI Board 1
Multifunction I/O Controller 0
EISA Interface 0
<Press any key to continue (q to quit)>
WARNINGS
No warnings to report.
Information Menu: Enter command >
next reply other threads:[~2001-06-05 12:25 UTC|newest]
Thread overview: 6+ messages / expand[flat|nested] mbox.gz Atom feed top
2001-06-05 10:23 jheumann [this message]
2001-06-05 12:47 ` [parisc-linux] 0.9ser can't install on D210 Richard Hirst
2001-06-05 13:00 ` Michael S.Zick
2001-06-05 12:57 ` Thomas Bogendoerfer
2001-06-05 21:04 ` Thomas Bogendoerfer
2001-06-11 13:21 ` jheumann
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=3B1CB312.1C9DBAB9@fonts.de \
--to=jheumann@fonts.de \
--cc=parisc-linux@thepuffingroup.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.