Re: problems with raidhotgenerateerror

[Steven Dake <sdake@mvista.com>]

You should try setting the raid device to faulty which will allow 
atleast the disk to be hot removed.

Thanks
-steve

Claudio Fleiner wrote:

>I was playing around with raid1 using two loopback devices of 4M each.
>The config file I'm using looks like this:
>
>raiddev /dev/md0
>          raid-level      1
>          nr-raid-disks   2
>          nr-spare-disks  0
>          chunk-size     4
>          persistent-superblock 1
>          device          /dev/loop0
>          raid-disk       0
>          device          /dev/loop1
>          raid-disk       1
>
>
>Everything works as expected, except that I cannot simulate an error using
>raidhotgenerateerror. The command runs just fine (as confirmed by the following strace,
>(all unnecessary stuff removed):
>
>execve("/home/cfl/prog/raidtools-20010914/raidhotgenerateerror", ["/home/cfl/prog/raidtools-20010914/raidhotgenerateerror", "-c", "c", "/dev/md0", "/dev/loop0"], [/* 58 vars */]) = 0
>open("/dev/md0", O_RDONLY)              = 4
>ioctl(4, 0x800c0910, 0x804f948)         = 0
>open("/dev/md0", O_RDWR)                = 5
>fstat64(5, {st_mode=S_IFBLK|0660, st_rdev=makedev(9, 0), ...}) = 0
>stat64("/dev/loop0", {st_mode=S_IFBLK|0660, st_rdev=makedev(7, 0), ...}) = 0
>ioctl(5, 0x92a, 0x700)                  = 0
>_exit(0)                                = ?
>
>but /proc/mdstat shows that loop0 is still OK (writing to the md0 device
>does not make a difference) and removing the drive using raidhotremove
>fails):
>
>Personalities : [raid0] [raid1] [raid5] 
>read_ahead 1024 sectors
>md0 : active raid1 [dev 07:01][1] [dev 07:00][0]
>      4032 blocks [2/2] [UU]
>      
>
>I'm using Redhat 7.2 with a 2.4.19 kernel.
>
>Any idea why this is not working?
>
>Thanks, Claudio
>
>
>
>-
>To unsubscribe from this list: send the line "unsubscribe linux-raid" in
>the body of a message to majordomo@vger.kernel.org
>More majordomo info at  http://vger.kernel.org/majordomo-info.html
>
>
>
>  
>