From: Jeff Garzik <jgarzik@pobox.com>
To: Linus Torvalds <torvalds@transmeta.com>
Cc: lkml <linux-kernel@vger.kernel.org>, netdev@oss.sgi.com
Subject: [BK PATCH] net driver merges
Date: Fri, 21 Mar 2003 00:29:27 -0500 [thread overview]
Message-ID: <3E7AA337.5000402@pobox.com> (raw)
[-- Attachment #1: Type: text/plain, Size: 0 bytes --]
[-- Attachment #2: net-drivers-2.5.txt --]
[-- Type: text/plain, Size: 8533 bytes --]
Linus, please do a
bk pull bk://kernel.bkbits.net/jgarzik/net-drivers-2.5
This will update the following files:
drivers/net/e100/e100_vendor.h | 311 -----
Documentation/networking/e100.txt | 9
Documentation/networking/e1000.txt | 132 +-
MAINTAINERS | 5
drivers/net/3c509.c | 44
drivers/net/8390.h | 3
drivers/net/Kconfig | 56 +
drivers/net/Makefile | 1
drivers/net/Makefile.lib | 1
drivers/net/Space.c | 2
drivers/net/at1700.c | 120 ++
drivers/net/e100/e100.h | 15
drivers/net/e100/e100_config.c | 21
drivers/net/e100/e100_config.h | 4
drivers/net/e100/e100_eeprom.c | 2
drivers/net/e100/e100_main.c | 272 +++--
drivers/net/e100/e100_phy.c | 38
drivers/net/e100/e100_phy.h | 4
drivers/net/e100/e100_test.c | 5
drivers/net/e100/e100_ucode.h | 2
drivers/net/e1000/e1000.h | 32
drivers/net/e1000/e1000_ethtool.c | 104 --
drivers/net/e1000/e1000_hw.c | 1920 ++++++++++++++++++++++++++-----------
drivers/net/e1000/e1000_hw.h | 303 +++++
drivers/net/e1000/e1000_main.c | 834 ++++++++++------
drivers/net/e1000/e1000_osdep.h | 24
drivers/net/e1000/e1000_param.c | 85 +
drivers/net/ne2k_cbus.c | 879 ++++++++++++++++
drivers/net/ne2k_cbus.h | 481 +++++++++
drivers/net/tg3.c | 8
30 files changed, 4243 insertions(+), 1474 deletions(-)
through these ChangeSets:
<jgarzik@redhat.com> (03/03/21 1.1189)
[netdrvr tg3] fix memleak in DMA test
Also, bump version to 1.5.
Leak fix contributed by Don Fry @ IBM
<cramerj@intel.com> (03/03/20 1.1171.1.17)
[E1000] NAPI re-insertion w/ changes
* Previous patch wiped NAPI support, adding it back here. But,
with a twist: this one doesn't disable/enable interrupts each
time we enter/leave polling. (It's EXPERIMENTAL).
<cramerj@intel.com> (03/03/20 1.1171.1.16)
[E1000] whitespace fix from previous patches
* Corrected indentation from previous patches
<cramerj@intel.com> (03/03/20 1.1171.1.15)
[E1000] Controller wake-up thru ASF fix
* Fixed controller wake-up through ASF
<cramerj@intel.com> (03/03/20 1.1171.1.14)
[E1000] Added Interrupt Throttle Rate tuning support
* Added Interrupt Throttle Rate tuning support
<cramerj@intel.com> (03/03/20 1.1171.1.13)
[E1000] Added Tx FIFO flush routine
* Added method to flush Tx FIFO after link disconnect; the hardware
hangs on to Tx skb's that were in flight prior to link loss
<cramerj@intel.com> (03/03/20 1.1171.1.12)
[E1000] Whitespace changes
* Miscellaneous whitespace changes
<cramerj@intel.com> (03/03/20 1.1171.1.11)
[E1000] Compaq to HP branding change
* Changed "Compaq" branding to "HP"
<cramerj@intel.com> (03/03/20 1.1171.1.10)
[E1000] Read/Write register macro optimizations
* Optimized E1000_*_REG macros
<cramerj@intel.com> (03/03/20 1.1171.1.9)
[E1000] Tx Descriptor cleanup
* Completely clean Tx descriptor to avoid potential dirty descriptor
fetching (rare, but possible)
<cramerj@intel.com> (03/03/20 1.1171.1.8)
[E1000] Perform single PCI read per interrupt
* ISR cleanup; performing single PCI read
<cramerj@intel.com> (03/03/20 1.1171.1.7)
[E1000] Modulus math removed
* Removed modulus math; decreases CPU utilization, especially on PPC64
[anton@samba.org]
<cramerj@intel.com> (03/03/20 1.1171.1.6)
[E1000] Added MII support
* Added MII support
<cramerj@intel.com> (03/03/20 1.1171.1.5)
[E1000] Added 82541 & 82547 support
* Added support for 82541 and 82547 gigabit ethernet adapters
<cramerj@intel.com> (03/03/20 1.1171.1.4)
[E1000] IRQ registration fix
* Fixed IRQ registration bug; IRQ now registered after resources are
acquired
<cramerj@intel.com> (03/03/20 1.1171.1.3)
[E1000] Spd/dplx abstraction; eeprom size changes
* Setting speed/duplex is now it's own routine
* Update ETHTOOL_GEEPROM routine to use new eeprom size variable
<cramerj@intel.com> (03/03/20 1.1171.1.2)
[E1000] Version, copyright, changelog and MAINTAINERS
* Version, copyright, changelog and MAINTAINERS updates
<cramerj@intel.com> (03/03/20 1.1171.1.1)
[E1000] Documentation/networking/e1000.txt updates
* Documentation/networking/e1000.txt updates
<tomita@cinet.co.jp> (03/03/20 1.1187)
[PATCH] Support PC-9800 subarchitecture (9/14) NIC
This is the patch to support NEC PC-9800 subarchitecture
against 2.5.65-ac1. (9/14)
C-bus(PC98's legacy bus like ISA) network cards support.
Change IO port and IRQ assign.
Add NE2000 compatible driver for PC-9800.
PCI netwwork card works fine without patch.
Regards,
Osamu Tomita
<scott.feldman@intel.com> (03/03/20 1.1186)
[E100] ASF wakeup enabled, but only if set in EEPROM
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Check if ASF is enabled in EEPROM, and if so, enable
PME wakeup when suspending.
<scott.feldman@intel.com> (03/03/20 1.1185)
[E100] ethtool EEPROM and GSTRING fixes
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Bug fix: read wrong byte in EEPROM when offset is odd number
* Bug fix: memory leak in ETHTOOL_GSTRINGS
[Oleg Drokin <green@linuxhacker.ru]
<scott.feldman@intel.com> (03/03/20 1.1184)
[E100] Validate updates to MAC address
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Validate updates to MAC address as valid ethernet address.
<scott.feldman@intel.com> (03/03/20 1.1183)
[E100] interrupt handler free fix
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Bug fix on e100_close when repeating hot remove/hot add
from team. Basically need to disable interurpts and
unregister handler before shutting h/w down.
* Need to mask only the relevant bits in the interrupt
status register
<scott.feldman@intel.com> (03/03/20 1.1182)
[E100] Honor WOL settings in EEPROM
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Honor WOL settings in EEPROM: only advertise WOL magic
packet if in EEPROM.
<scott.feldman@intel.com> (03/03/20 1.1181)
[E100] ICH5 support added
On Thu, 20 Mar 2003, Scott Feldman wrote:
* ICH5 support: chipset integrated LAN (8255x)
* PHY loopback diags is broken on all ICHs
<scott.feldman@intel.com> (03/03/20 1.1180)
[E100] forced speed/duplex link recover
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Bug fix when changing to non-autoneg, device may lose
link with some switches, so try to recover link by
forcing PHY.
<scott.feldman@intel.com> (03/03/20 1.1179)
[E100] Banish strong branding marketing strings
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Get rid of all of the strong marketing brand strings
and replace with simple pci_device_id table. pci.ids
should be the master list for device ID/strings.
<scott.feldman@intel.com> (03/03/20 1.1178)
[E100] Bug fix on setting up Tx csum
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Bug fix on setting up Tx csum
<scott.feldman@intel.com> (03/03/20 1.1177)
[E100] Clean up #include order
On Thu, 20 Mar 2003, Scott Feldman wrote:
* clean up #includes
<scott.feldman@intel.com> (03/03/20 1.1176)
[E100] Add support for VLAN hw offload
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Add support for VLAN hw offload
<scott.feldman@intel.com> (03/03/20 1.1175)
[E100] Spelling mistakes
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Spelling mistakes
<scott.feldman@intel.com> (03/03/20 1.1174)
[E100] update version, copyright year, changelog
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Update version, copyright year, changelog
<scott.feldman@intel.com> (03/03/20 1.1173)
[E100] Update Documentation/networking/e100.txt
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Update Documentation/networking/e100.txt
<scott.feldman@intel.com> (03/03/20 1.1172)
[E100] back out memleak patch cuz it messed up following
On Thu, 20 Mar 2003, Scott Feldman wrote:
* Back this patch out - we'll add it later. I was working against
2.5.64 when this was checked into 2.5.65, so it messed up
my patches.
next reply other threads:[~2003-03-21 5:18 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2003-03-21 5:29 Jeff Garzik [this message]
2003-03-21 21:38 ` [BK PATCH] net driver merges Jason Lunz
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=3E7AA337.5000402@pobox.com \
--to=jgarzik@pobox.com \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@oss.sgi.com \
--cc=torvalds@transmeta.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.