Re: 2.5.70-mm2

[Boszormenyi Zoltan <zboszor@freemail.hu>]

Boszormenyi Zoltan wrote:

> OK, compiled as built-in, not too many problems left. 


One problem is found: I enabled ACPI and disabled APM.
On poweroff, I got an oops after every service stopped.
I was able to read some lines vaguely, it wrote something about
"acpi_poweroff called", "IRQ#20 disabled", but I was not able to
write the oops down because the machine switched itself off.

Here are some info I was able to gather:
ASUS P2B-D with 2 PIII/500

# lspci -s 00:04.3
00:04.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 02)
[root@catv-50622120 proc]# lspci -s 00:04.3 -vvv
00:04.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 02)
        Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR- FastB2B-
        Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Interrupt: pin ? routed to IRQ 9
# cat interrupts
           CPU0       CPU1
  0:      23121     462231    IO-APIC-edge  timer
  1:       2493         11    IO-APIC-edge  i8042
  2:          0          0          XT-PIC  cascade
  8:          1          0    IO-APIC-edge  rtc
 12:       9135        756    IO-APIC-edge  i8042
 14:      14296       2371    IO-APIC-edge  ide0
 15:       4055       1804    IO-APIC-edge  ide1
 16:          1         90   IO-APIC-level  eth1
 19:        373          4   IO-APIC-level  eth0
 20:          0          0   IO-APIC-level  acpi
NMI:          0          0
LOC:     485147     485151
ERR:          0
MIS:          0

Best regards,
Zoltán Böszörményi