[lm-sensors] sensors trouble

[Jonathan Murphy <typetosmurky@yahoo.com.au>]

Hi Folks,

I can't get sensors working. Kernel is 2.6.22.1, lm_sensors-2.10.4. 

Relevant lspci:

00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin IV]

Relevant config:

CONFIG_I2C=y
CONFIG_I2C_ALI1535=m
CONFIG_I2C_ALI15X3=m
CONFIG_SENSORS_EEPROM=m

Output of sensors-detect:

We can start with probing for (PCI) I2C or SMBus adapters.
Do you want to probe now? (YES/no): y
Probing for PCI bus adapters...
Use driver `i2c-ali15x3' for device 0000:00:11.0: Acer Labs 1533/1543
Use driver `i2c-ali1535' for device 0000:00:11.0: Acer Labs 1535

We will now try to load each adapter module in turn.
Load `i2c-ali15x3' (say NO if built into your kernel)? (YES/no): y
Module loaded successfully.
Load `i2c-ali1535' (say NO if built into your kernel)? (YES/no): n
If you have undetectable or unsupported adapters, you can have them
scanned by manually loading the modules before running this script.

To continue, we need module `i2c-dev' to be loaded.
Do you want to load `i2c-dev' now? (YES/no): y
Module loaded successfully.

[....]

Sorry, no sensors were detected.
Either your sensors are not supported, or they are connected to an
I2C or SMBus adapter that is not supported. See doc/FAQ,
doc/lm_sensors-FAQ.html or http://www.lm-sensors.org/wiki/FAQ
(FAQ #4.24.3) for further information.
If you find out what chips are on your board, check
http://www.lm-sensors.org/wiki/Devices for driver status.


However, if I run sensors-detect choosing i2c-ali1535 instead, then I
get:

Next adapter: SMBus ALI1535 adapter at 8040 (i2c-0)
Do you want to scan it? (YES/no/selectively): y
Client found at address 0x50
Probing for `Analog Devices ADM1033'...                     No
Probing for `Analog Devices ADM1034'...                     No
Probing for `SPD EEPROM'...                                 Success!
    (confidence 8, driver `eeprom')
Probing for `EDID EEPROM'...                                No
Probing for `Maxim MAX6900'...                              No
Client found at address 0x51
Probing for `Analog Devices ADM1033'...                     No
Probing for `Analog Devices ADM1034'...                     No
Probing for `SPD EEPROM'...                                 Success!
    (confidence 8, driver `eeprom')


However sensors gives:

No sensors found!
Make sure you loaded all the kernel drivers you need.
Try sensors-detect to find out which these are.

Thanks in advance,
Jonathan.



_______________________________________________
lm-sensors mailing list
lm-sensors@lm-sensors.org
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors